Author: Forum News

hello everyone!

im new to the forum , just picked up an old 2000 magnum 500, sold my 88 Suzuki in the fall, and bought this for the up coming season

have been tearing it apart to make sure everything is snug

so i have been looking into bigger tires , and i have a stupid question,

so im looking at 27" swamp lights for front and rear the set im looking at are 9" wide, will i run into any problem mounting them on (7" aftermarket rear)& (8" stock front) wide rims?

also i know the tierod end is pretty close to the tires already so im assuming im looking at wheels spacers for the front, one day when its nice out soon, gonna bust out the measuring tape and get an idea of where abouts everything will stick out too,

also i took a quick look at the front lockers, im thinking of just wiring those lockers to a switch so its just on or off, not having to worrie about the over ride switch ect (my day job is electronics&computers)

i also plan on waterproofing, snorkle, rad relocate,

where would i go to check to see if all the u joints on my front and rear prop shaft are the same or not, I have checked it out online and ive got mixed info. but seem the car quest 338 bearing is the go too


thanks again everyone , sorry for the boat load of questions and rambling , if anyone has pointer plz let me know :)

Manual calls for throttle lubing but I have heard of anyone doing it.... Does anyone do it ?

Just bought my first 4 wheeler to do some work around the house. I am wanting to do some maintenance and clean carb etc but haven't been able to find a service manual in the sites posts.. Could anyone help with carb cleaning procedure or a service manual? Thanks

Hello folks.

I’m looking into upgrading to aluminum handle bars on my outty 570. Not really sure what to go with. I would like a similar bend to stock. I see the “CR” bend is popular/common and I’m considering the “Atv high bend”. 7/8” bars should be fine for my needs.

I don’t want a cross bar. Would like better visibility of the gauge pod and would like to use a square bar pad.

I also want risers. The stock height is ok but could be taller. I’m 6’1” I see roxspeed fx has a nice pivot riser as well as powermadd. Which best fits the Can am? 2” rise should be plenty.

Also some thoughts on hand guards and hand grips would be a plus.

Thanks guys!

i have a 2012 rzr xp 900 with a completly blown up front diff.can a 1000 front diff be installed,if so what mods needed and are gear ratios the same?

i have a 2012 rzr xp 900 with a completly blown up front diff.can a 1000 front diff be installed,if so what mods needed and are gear ratios the same?

Hey is anyone done a rear differential shaft seal on outlander 800R. What is the quickest way to do this without having to disassemble a ton of shit. please let me know.

can a front diff out of rzr1000 be put in a 2012 rzr 900xp?any mods need to be made and is gear ratio the same?

Only one wheel locks and engages and it just flat out won’t pull when under a load. What should i be checking?

We are new to the world of ATV's, we ( my wife and I) are a bit older than most, but we like to party like we are still 30 years old, LOL

I am an HVAC contractor and Im willing to help those with questions about there systems ~~~ AS LONG AS IT's NOT ABOUT OIL HEAT, I freak'n hate oil heat.

I love God, Country, and family

I hope to learn a lot about ATV's from the folks here. I like to work on my own stuff, cars, Trucks, boats and now ATV's