Author: Forum News

Used it for the firstborn time today.
Made life easy.

My question is why aren’t the front wheels “on” when the switch is in “ADC 4x4?”

Regular 4x4 shows them on.

Attached Thumbnails

   

I put a new carb on an 04 700 but I have a lean spot when I blip the throttle. How do I richen it up?

Considering my new 2018 machine coded after 5 hours of running, I'm wondering if I should get the extended warranty? Without reading into it, not sure what all is covered so I thought I'd throw it out there..........any suggestions?

Hey new to the forum, gonna buy a magnum 325 this weekend, iv seen some floating around with a 2 inch lift but the only one I could find were for the magnum 330s or higher. Would a lift for a 330 or 500 work on a 325? Any info would help. Thanks

I seemed to have mis-placed my manual. Can anyone tell me the capacity? or where to look to find it?

Thanks

I have a 02 Sportsman 500 H.O. It is in the constant stage of loosing coolant. Not a lot just regularly until there is finally none in the overflow container. It warms up and pressure causes small amount of coolant to be lost through overflow into the overflow container and out that cap. When it cools the coolant goes back down. After several of these times the level in the overflow goes to empty. Any ideas? I've replace the radiator cap... same thing. It's happening to my 2012 also. was thinking of putting the overflow container at a higher point...wondering if that might help. Any ideas?

New guy - picking up a well maintained 2007 Sportsman 800 this week. I rode these beasts in Afghanistan and absolutely loved them. My goal is to turn this quad into a twin of the beauty I had back in Kandahar. Oh, and I’m looking forward to taking it trail riding and hunting too!

Hey i have an 07 400 outlander and i wondered if anyone knew what would cause a coolant temp light to stay on all the time even when it's cold..and how to test the temp sensor? There are 2 connectors on the sensor and they don't have continuity.

I am replacing the wheel bearings on my 2004 Sportsman 500, who makes a good aftermarket bearing

Looking for an opinion as to whether or not to add bumpers and a front-only skid plate to my new 450 DPS. It will be primarily used for light ranch work and pulling a 52" rough-cut mower to knock down tall grass and thin brush. The area has already been cleared of obstacles.

Thanks!