Posted on

Snow plow

Hello, I'm about to pull the trigger on a plow for my outlander 850. Have narrowed it down between a warn pro vantage front mount, kfi, and kimpex. Anyone have any opinions, advice, or any other help? Any help is appreciated.

Thanks
Ryan
Posted on

starting issue when cold

I have a 650 outlander,2012 year and if its cold it has this issue starting. When you turn the key on it will not start, will not turn over, will not do anything. If you just let it sit with the key on for a while all of a sudden the lights will come on and then it will start up. You can then run it, stop it and shut it off and it will work fine. But let it sit for 2-3 hours it does it all over again. ????
Posted on

No spark

I have a DS90 4 stroke that I bought for my grandson. It was running when it was parked 7 years ago. I cleaned the carb and all the fuel lines but when I tried to start it it doesn't fire up. I'm not getting any spark at the plug. I checked every connection terminal and the 2 fuses I found they all look fine. I need some help with what to check next. I don't want to start replacing parts that may or may not be faulty.
Posted on

Running issue

Other night the wife's bike started idling poorly, shutting off, back fires under throttle then stalls.. will start roughly and idle then die.. no check engine light so no codes.. battery is full charge, spark plug looks fine, swapped MAP sensor off my sons 570 to it and made no difference..has good fuel and pump is working fine.. any ideas?
Posted on

light wiring

I was putting the finishing touches on the 1995 300 4x4 I'm bringing back to life and noticed something that likely shouldn't be wired the way it is.

The 2 'fog' lights on the left and right of the front grill are spliced directly into the wires of the center headlight, so they all run from the same wire(s).

I don't think this model year came with a grill on the front at all, but the previous owner put 1991 plastics, and I'm assuming the front grill onto the bike.

I'm planning on installing an inline fuse and running the 2 new led fogs I bought from their own terminal on the block.

I have an open terminal on the block on the right side (middle) that shows 12v when the key is turned on.

Am I safe to wire the fog lights to this terminal, or is there a specific terminal I should be using for that?
Posted on

Big bore kit?

Is there any companies offering a big bore kit for these? I bought an XP 1000 that had been swamped and looking at engine rebuild kits and found one from BP racing but it’s only for the RZR’s. Would be great if I could find something similar for my scrammy.
Posted on

Bellows on the vents

Anyone running bellows or bladers on their differential vents I know it's big in the can am world and would like to do it on my polaris to keep water and mud out.