Author: Forum News

Legends Keto As such converting the pattern will once a sufficient amount of time has surpassed permit your healthy eating plan or weight reduction capsules to emerge as powerful once more This trick essentially involves difficult the human metabolism and is frequently taken as a as an

http://www.kingofsupplement.com/legends-keto/

I have recently purchased my first Polaris ATV and as I read about them I always come across posts about something being weak and needing to be updated. I've seen mention of updated differential covers, brackets, and even braces... With that said, what are the weak spots on the 2011 Sportsman 500 HO? I would like to take care of them before they become a problem!

I got my tires on the rims but I can’t get them to take air?

Attached Images

File Type: jpeg

2F14FB97-3D84-411F-B011-B501AB19E5A3_1553475535465.jpeg (1.31 MB)

So here is the story - bought this 98 400 for my son - when checking the fluids found no AF - Filled it and started the quad instant water fall . Bad head gasket - replaced same and ran good - went out to ride for the first time today and after about 20 minutes quad just died and will no restart - I am going to check compression but I am pretty sure it need to be bored and new piston / rings due to previous owner running it with no coolant - thinking of doing a complete engine rebuild - anyone have suggestions ? Anyone know how tough it is to get the engine out of the frame on this model ?

Hi guys. I joined about a month ago and started a thread about the 2018 vs 2019 Outlanders before I made the decision what I was getting. I just bought a 2018 Outlander 850 DPS. I love it so far. I like to do trail riding and will probably use my quad to do work here and there. My first brand new quad, moving from my dads 2001 King quad 300.

Attached Images

File Type: jpg

Feb-23 new quad .jpg (100.6 KB)

I have a 2016 renegade 850 xxc, the oem heated grips were unbelievably week, I bought new heat demon grips thinking it would resolve the problem. They are just as weak, on full power they are barely luke warm what could the problem be?

New to the forum. I’ve been having a hard time finding and info on this machine. I’ve only had it less then a year. Long story short it runs fine then after getting on it it won’t rev up anymore and starts back firing. After it sits for a little bit it runs fine. I read about possible ground issue on the control causing it to go in limp mode. Is their a way to bypass the Rev limiter? It’s pretty annoying in reverse. I cleaned carb, fuel pump, checked check valves. Thanks

What flex bar bend is everyone running? I am getting 2 in riser and can’t decide on the bend I am 6 foot