Hello, I recently purchased a 2003 Raptor 660R. I went to DOL in Covington,WA. I applied for title. Etc. They sent me away with registration. A month sticker. And a year sticker (looks exactly like a car tab) Few weeks later. I get a green plate that says Washington restricted vehicle on top of it. With two spots for on road and off road tabs. My question is. How do I get an off road tab? This is my first off road vehicle in Washington state. So I'm not sure what I should do. Or who to contact. Or if I should just take what I've got to Moses lake and see what happens.
Predator 500 will start but have to hold hand over the carb.
Hey guys I have an 04 preddy 500,I'm having trouble getting it started 99% of the time. I HAVE to hold my hand over the carburetor until it spits back some gas then remove my hand and it tries to fire sometimes it will start up and run and other times I just have to repeat those steps. I've cleaned the carburetor thoroughly, put new piston rings in it, and a new choke cable and just cant figure it out. Would anybody know what it could be? I know I set the timing right, i have a sneaking suspicion it's the valves.
2001 Scrambler 400 Counter Balance Removal
Hey folks, does anyone have experience removing and replacing the counter balance?
My issues started with a water leak from the water pump. Pulled and replaced the pump and seals. Counter balance is too pitted to clean up and seal. The bike started leaking again.
I need to pull and repair or replace the counter balance.
Does the oil pump need to be removed? I've heard yes and no.
Can the counter balance be repair?
Does anyone have a link to a service manual with detailed instructions?
Thanks for the help!
Sent from my iPhone using Tapatalk
My issues started with a water leak from the water pump. Pulled and replaced the pump and seals. Counter balance is too pitted to clean up and seal. The bike started leaking again.
I need to pull and repair or replace the counter balance.
Does the oil pump need to be removed? I've heard yes and no.
Can the counter balance be repair?
Does anyone have a link to a service manual with detailed instructions?
Thanks for the help!
Sent from my iPhone using Tapatalk
06 800 stumped
Have bike not working properly
I have new fuel pump tested 51lbs
New cam sensor
New maf,new plugs injectors both are good as I have switched from front to back no change . Good compression both cylinders and no engine codes or lights on. Start bike it idles for a few seconds then stalls hit switch starts back up I get the bike to idle but its rough as the rear cylinder isnt working I pull injector plug no change to engine. I checked pulse and it's good I had ignition analyzer and it's good. WTF? There is no reason the bike shouldnt be running. The valves have been adjusted and set now then I pull the plugs they are both white. When it's running it seems to hit and miss but the injection pulse stays active cant seem to figure this out. Any chance it's the speed sensor . Sounds stupid to me as I havent driven the bike in this condition. Not burning coolant and I've taken a propane torch without lighting it just turned gas on to check for a leak and nothing. This is a real head scratcher.
I have new fuel pump tested 51lbs
New cam sensor
New maf,new plugs injectors both are good as I have switched from front to back no change . Good compression both cylinders and no engine codes or lights on. Start bike it idles for a few seconds then stalls hit switch starts back up I get the bike to idle but its rough as the rear cylinder isnt working I pull injector plug no change to engine. I checked pulse and it's good I had ignition analyzer and it's good. WTF? There is no reason the bike shouldnt be running. The valves have been adjusted and set now then I pull the plugs they are both white. When it's running it seems to hit and miss but the injection pulse stays active cant seem to figure this out. Any chance it's the speed sensor . Sounds stupid to me as I havent driven the bike in this condition. Not burning coolant and I've taken a propane torch without lighting it just turned gas on to check for a leak and nothing. This is a real head scratcher.
Sportsman 850 xp fender flares pics opinion
Hey guys I'm new to the forum and I have a 2014 polaris sportsman 850 xp on 29s and I have just mocked up my fender flares but I think they might rub. I haven't been able to ride yet and if hate to drill all the holes to find out later. Also not sure about the look? What do you guys think? I'm also running 1.5 inch spacers
Thanks
Thanks
98 and older sportsman 500s
Hey guys. Looking at trading my 09 dragon 800 sled for a couple quads. Buddy is offering a 2000 Honda ex400 (I'd sell) and a sportsman 500. He said it's a 2000 but looking at pics online it looks like it would be 98 or older as it has an analogue tach. At any rate it's only got 800 miles on it and he says it runs great. I was kinda hoping to get something a bit newer. I guess my main question is are these still worth getting and how much better are the newer ones over the older ones? This will be my first quad but my father has a 08 (I believe) sportsman which I think is also a 500 I've ridden a bunch of times. Anything I should look out for when making the trade or should I just hold out for something more modern? Mainly looking for something reliable that I can rip on trails with friends, 2up with the gf and I'd like to put a plow on it for winter as I can contract through my work for like $90 an hour when it snows! Reliability is the main thing but I also don't want it to be crazy low on power. All my friends ride 660s and higher, am I going to be able to keep up?
http://imgur.com/s8xVDyK
Http://imgur.com/OgOCk14
http://imgur.com/s8xVDyK
Http://imgur.com/OgOCk14
Used outlander
Hello all, I'm sure something similar to this has been posted, but I couldn't find something exactly like what I'm looking for. If there is something please redirect me.
Anyways, I'm looking to get a used ATV for around $5,500, could go a little more. I've seen some 2013 - 2014 Outlander 1000 xt's for right around that price with around 2k miles on them. Is that too many miles? I haven't seen any, but I assume I can get an 850 xt with around 1k miles for the same price. I'm planning on doing mostly trail riding here in Massachusetts and may eventually throw a plow on the machine. I don't plan on beating on this machine at all and am hoping for something that will get me close to 5k miles with regular maintenance. I've been told I should be looking at a 2014 Grizzly 700 with 500-1000 miles, but figured I'd come here for some suggestions. I know the Outlanders power will be much stronger than the grizzly's, but from what I've read the grizzly's require very little maintenance. Will the extra power be worth the extra maintenance? If I did go with the Outlander how much should I expect to pay yearly to maintain the thing? $250? $500? I'm coming from a 2 stroke dirt bike that cost me $100-$200 a year to maintain.
Any advice/suggestion is appreciated.
Thanks,
Nick
Anyways, I'm looking to get a used ATV for around $5,500, could go a little more. I've seen some 2013 - 2014 Outlander 1000 xt's for right around that price with around 2k miles on them. Is that too many miles? I haven't seen any, but I assume I can get an 850 xt with around 1k miles for the same price. I'm planning on doing mostly trail riding here in Massachusetts and may eventually throw a plow on the machine. I don't plan on beating on this machine at all and am hoping for something that will get me close to 5k miles with regular maintenance. I've been told I should be looking at a 2014 Grizzly 700 with 500-1000 miles, but figured I'd come here for some suggestions. I know the Outlanders power will be much stronger than the grizzly's, but from what I've read the grizzly's require very little maintenance. Will the extra power be worth the extra maintenance? If I did go with the Outlander how much should I expect to pay yearly to maintain the thing? $250? $500? I'm coming from a 2 stroke dirt bike that cost me $100-$200 a year to maintain.
Any advice/suggestion is appreciated.
Thanks,
Nick
15 ETX 325 2×4 won’t rev up
Acts like gelled needle and seat but is EFI model. Will start but you can't give it gas. Has sat for about 1 1/2 year. carb easy to get to but I'm not sure what to clean. Please help.
15 ETX 325 2×4 won’t rev up
Acts like gelled needle and seat but is EFI model. Will start but you can't give it gas. Has sat for about 1 1/2 year. carb easy to get to but I'm not sure what to clean. Please help.
2001 DS650 base model
Hi all:
Have a question about my 2001 DS650 regarding the radiator cooling fan. Before folks go telling me to remove my fan and buy a new one, let me say that MY FAN has been tested against the ATV battery and works quiet and powerful! I just wish I would run by heat trigger. So here we go...
I am yet to see my fan actually triggered and blowing heat away from my radiator by way of the Coolant sending unit. I've done all tests that I have been told to do.........I THINK! Anyway, I was told to do a pig tail test after removing the two wires from my sending unit and when turning the key on, the fan should run.... NOT! I have also replaced my fuse with a new one just to cover my butt. I do not have a relay on my 2001 base model and I suspected that my system is straight wired with my battery set up with my ignition switch just like if I was to unplug my fan and run a ground wire from one of the fan leads to one pin on my heat sending unit and the other fan lead, positive run to the negative side of my battery and then from the positive side to the other sending unit plug using it as a type of automatic toggle switch. I've been also told to toggle switch my fan so it can run on demand or triggered with the key.
OK, I don't want to do any of that and i just want my system to run as it did from the factory. Now, with all my info I have given, what else could go wrong?? Is that other item near the sending unit only to the top with the one wire hooked to it important and is that part of my red warning light trigger on my dash? I've tried my Ohm tester on continuity by hooking up a jumper at the sending unit end and testing from the unplugged fan end and get nothing and vise versa. I will include a photo of the two items in question and I just don't know what to do from here and until I can run the fan by jumper with the key switch on, replacing the two sending units don't mean anything even if the were bad. My testing problem is in between somewhere else. Can someone explain the route starting from the fan and what wires route to where from the key switch to the battery and to the sending unit.
I have been all over the internet and have not found a clear picture or a fix, nor even how to test for faults. I hope I covered everything. Thanks. Scott
Have a question about my 2001 DS650 regarding the radiator cooling fan. Before folks go telling me to remove my fan and buy a new one, let me say that MY FAN has been tested against the ATV battery and works quiet and powerful! I just wish I would run by heat trigger. So here we go...
I am yet to see my fan actually triggered and blowing heat away from my radiator by way of the Coolant sending unit. I've done all tests that I have been told to do.........I THINK! Anyway, I was told to do a pig tail test after removing the two wires from my sending unit and when turning the key on, the fan should run.... NOT! I have also replaced my fuse with a new one just to cover my butt. I do not have a relay on my 2001 base model and I suspected that my system is straight wired with my battery set up with my ignition switch just like if I was to unplug my fan and run a ground wire from one of the fan leads to one pin on my heat sending unit and the other fan lead, positive run to the negative side of my battery and then from the positive side to the other sending unit plug using it as a type of automatic toggle switch. I've been also told to toggle switch my fan so it can run on demand or triggered with the key.
OK, I don't want to do any of that and i just want my system to run as it did from the factory. Now, with all my info I have given, what else could go wrong?? Is that other item near the sending unit only to the top with the one wire hooked to it important and is that part of my red warning light trigger on my dash? I've tried my Ohm tester on continuity by hooking up a jumper at the sending unit end and testing from the unplugged fan end and get nothing and vise versa. I will include a photo of the two items in question and I just don't know what to do from here and until I can run the fan by jumper with the key switch on, replacing the two sending units don't mean anything even if the were bad. My testing problem is in between somewhere else. Can someone explain the route starting from the fan and what wires route to where from the key switch to the battery and to the sending unit.
I have been all over the internet and have not found a clear picture or a fix, nor even how to test for faults. I hope I covered everything. Thanks. Scott