Posted on

Gsp xtv axles?

So I ordered demon HD axles, and got gsp xtv axles for my bike, any opinions on which is better? 2” bracket lift and 29.5 inch swamp lites, I need the better option, do I put em on and run em, or return them and get the demons?
Posted on

Limp Home

I have a 2017 outlander 570 its over heating fan not working , I have checked relay and fuse also un plugged fan and tried direct 12v still dose not work. Any other suggestions before buying new Fan ?
Posted on

1999 sportsman 335, I need a new cam

I'm looking for a cam. The bike was bogging out at full throttle. Rebuilt the carb now the bike wont go anywhere, no power. I was told I need a new cam shaft. Polaris discontinued the part. I been searching the web, No luck. If anyone has one or can point me in the right direction please email me. jeff.gimon78@gmail.com
Posted on

02 325 Magnum carb rebuild ?

2002 325 Mag. - I rebuilt my carb. with Moose kit 1003-0513 because I wasn’t getting enough gas or no gas to the carb. and everything else checked out. I also removed the screen/filters inside the gas tank and cleaned. Air filter & fuel pump is new.
2 things I noticed during disassembly were my air/fuel mixture screw didn’t have an o-ring or washer like what is in the kit. Also the main jet I removed said 120 and an “R” with a little square box next to it. The new main jet had 145 on it, which I installed. I also installed the new mixture screw with spring, o-ring and washer. I made sure to turn the original air/fuel mixture screw in before removing which was 2-1/2 turns.
When I fired it up it ran great, idled well, rev’d it a little and ran smooth but when I opened it up it makes a steady chatter noise like it isn’t getting enough gas or to much? So my question is – do you think the main jet is the wrong size from the kit ? Or your thoughts that might be causing the problem ?
Greatly appreciate any knowledge on this !
Posted on

’02 700 carb diaphragm spring

The spring on the diaphragm keeps popping out and lodging sideways when i pull the top cover off. I have checked the diaphragm for holes and could not find any. The atv will not hardly run when this happens. I have repaired it twice. Any ide why this would happen? Everything is clean and in good condition.