Category: Forum News

I have some leftover Can-Am accumulated Parts if anyone is interested. Set of brand new one way clurch bearings, with a small tube of Isoflex, good multifunction switch, Ricochet skid plates 'a' arms only, set of 4 for all g2's. Center Mount Plow Mount for G2's, couple of Double D bushings for the sway bar. OEM ball joint, American Star tie rod sets slightly worn ends, Hime Style ,and a service manual CD all yours for the very low price of...

PM me please...

All sportsman twin owners, I have 2011 EFI 800 twin sportsman, while trail riding and then fan comes on it will blister (2nd & 3rd degree burns) on my right leg. Does any else have this problem? I built a heat shield but now i can hear boiling fuel in the tank. Is there solution from Polaris if this is not an isolated problem to only me.

Hi guys,

Been reading all threads regarding starting issues. So basically the bike will only start when either hand or foot brake is applied and as per the info I found it could be the neutral park position switch/sensor (correct name?).
Is this sensor the 3 nuts with wires in the attached pic? They have a rubber coating. How do I check them?
Have not been able to findo more specifics.

Thanks

Sent from my SM-G920I using Tapatalk

ATV wheel bearing replacement diy. Simply pre soak the old bearing and tap it out or use a press. Now freeze the New bearing overnight and heat the aluminum hub with the heat gun. Take your time as you do not want the bearing to get stuck halfway in the housing. Thanks for Watching and feel free to Comment with questions below!

I am thinking about some upgrades to my stock 2016 850xt this winter. I use it in the mountains of Colorado, not much for mud at all. Mostly rocks and hard pack- and under 25 mph. Thinking of replacing the stock shocks, tires, and adding some skid plates. What would you recommend first to last, and why.
Thanks-

With some of the plastic panels off to do the valve adjustments this past weekend I noticed coolant in the "leak indicator hose" off the water pump. From what I can find from online search and brp manual this calls for replacing rotary seal and oil seal. I will work on getting these seals replaced in water pump sometime soon.

Do you guys know of any good online source(s) for parts and special tools? Manual calls for rotary seal pusher plate (p/n 529 036 130) and seal pusher pin (p/n 529 035 766) in addition to the 2 aforementioned seals.

Regards,

starter seemed to have slowed down, replaced it with a new one, but found the old one to saturated with engine oil, maybe a rear seal pushed out, pulled the engine to have a look found the crank seal appear ok, and the others to look ok as well, what caused the oil to be in that area ? is my question.


oil level has always been good as i check it often, when removing the engine there was a lot of oil drain out of the flywheel area.


2013 850 ho sportsman xp

Starting to look a lot like Christmas around here. 70+ degrees here yesterday, and now this today...

Attached Thumbnails

 

What cases are available for an AR-15 ? I don't want to use a rack that exposes my AR to dust and mud. I don't want to throw it in a cargo box and beat up the scope.

Thanks for any help!

Just wondering if there is a place to get a LCD odometer fixed or a place to buy a new LCD. The speedometer part works good, Just can't read the hours or miles.Thanks...