I have a 1999 sportsman 335 with 23X7-10 on front and 24X11-10 on back. Will I damage gears by going to 24's on front and 25s on back?
Tires
I have a 1999 sportsman 335 with 23X7-10 on front and 24X11-10 on back. Will I damage gears by going to 24's on front and 25s on back?
Newb Axle Question
Hey guys. I recently purchased a 2005 (says 50th anniversary) Sportsman 500, and i need to replace the LR axle. The boot is ripped, and it skips and clunks and jumps pretty bad when i do sharp turns.
My question is this: It says it a 2005, but its the non-square headlight style. All of the axles im finding seem to be for the 2002-2005. Is the body style i have still the same rear axles as the older models?
Thanks for your help!
Mine:
My question is this: It says it a 2005, but its the non-square headlight style. All of the axles im finding seem to be for the 2002-2005. Is the body style i have still the same rear axles as the older models?
Thanks for your help!
Mine:
interior very hot
just purchased a 2017 1000 commander. When riding the interior is very hot to the point of uncomfortable. There is hot air that blows up in the holes in the floor. If you are wearing shorts you will want to keep your legs out the door. Drinks put in the cup holders become to hot to drink. Looking under I can see just some reflective tape to keep the heat out. Is anyone else have this issue? Are there any aftermarket heat shields? I have looked but cant find any.
Thanks Keith
Thanks Keith
Need help with Outlander 330
Hello everyone.
So one of mine is giving me an issue.
what is causing the horrible high pitch sound when pressing the starter button. see video below.
https://youtu.be/5zOslqGo0Bs
I know the plastic reduction gear cover is broke and that's what was causing the rattling after it started but what is causing the horrible noise when I hit the start button? It fires right up and the starter gear appears to be working correctly because it engages and disengages from what I can see with the cover off it. I pulled the starter out earlier and bench tested with a 12v power supply. It spun with no issues and no noise but I'm wondering if it is because there was no resistance on it. Any ideas???
So one of mine is giving me an issue.
what is causing the horrible high pitch sound when pressing the starter button. see video below.
https://youtu.be/5zOslqGo0Bs
I know the plastic reduction gear cover is broke and that's what was causing the rattling after it started but what is causing the horrible noise when I hit the start button? It fires right up and the starter gear appears to be working correctly because it engages and disengages from what I can see with the cover off it. I pulled the starter out earlier and bench tested with a 12v power supply. It spun with no issues and no noise but I'm wondering if it is because there was no resistance on it. Any ideas???
Charging gremlin
Ok , I’m at a loss now.
2013outlander 1000xmr , battery not charging. Has died on last run when using lights.
Recharged battery.
Disconnected all aftermarket accessories. Checked all fuses , Checked main grounds from batt to frame and engine , checked batt + cable and negative connections, checked for voltage from mag ( 19v and up ) checked voltage at output of regulator ~15v ,
Check voltage at battery while running idle , 12.3 , under acceleration still 12.3 V.
Any ideas out there ?
Sent from my iPhone using Tapatalk
2013outlander 1000xmr , battery not charging. Has died on last run when using lights.
Recharged battery.
Disconnected all aftermarket accessories. Checked all fuses , Checked main grounds from batt to frame and engine , checked batt + cable and negative connections, checked for voltage from mag ( 19v and up ) checked voltage at output of regulator ~15v ,
Check voltage at battery while running idle , 12.3 , under acceleration still 12.3 V.
Any ideas out there ?
Sent from my iPhone using Tapatalk
Charging gremlin
Ok , I’m at a loss now.
2013outlander 1000xmr , battery not charging. Has died on last run when using lights.
Recharged battery.
Disconnected all aftermarket accessories. Checked all fuses , Checked main grounds from batt to frame and engine , checked batt + cable and negative connections, checked for voltage from mag ( 19v and up ) checked voltage at output of regulator ~15v ,
Check voltage at battery while running idle , 12.3 , under acceleration still 12.3 V.
Any ideas out there ?
Sent from my iPhone using Tapatalk
2013outlander 1000xmr , battery not charging. Has died on last run when using lights.
Recharged battery.
Disconnected all aftermarket accessories. Checked all fuses , Checked main grounds from batt to frame and engine , checked batt + cable and negative connections, checked for voltage from mag ( 19v and up ) checked voltage at output of regulator ~15v ,
Check voltage at battery while running idle , 12.3 , under acceleration still 12.3 V.
Any ideas out there ?
Sent from my iPhone using Tapatalk
What to buy
Looking to sell one of my 250 Trailblazers for something I can plow with. I am far from a Polaris engine newbie since I have been riding Polaris snowmobiles since 1992 and currently own 14 Polaris snowmobiles and/or watercraft.
I don't want to put chains on tires and mark my driveway up. I live in mid Michigan where I get some snow but nothing like the northern part of the state. Prefer a US built Polaris engine that is carbed. What would you suggest in $3,000 range? Any year or CC I should stay away from? Thanks
I don't want to put chains on tires and mark my driveway up. I live in mid Michigan where I get some snow but nothing like the northern part of the state. Prefer a US built Polaris engine that is carbed. What would you suggest in $3,000 range? Any year or CC I should stay away from? Thanks
Where is the spark plug located at on the Bombardier Outlander 330?
I want to tune up my Bombardier Outlander 330 but i cant find the location of the spark plug. CAn anyone help me?
Where is the spark plug located at on the Bombardier Outlander 330?
I want to tune up my Bombardier Outlander 330 but i cant find the location of the spark plug. CAn anyone help me?