98 Polaris Xplorer 400 Rebuild Questions

Hey everyone. Been on the forum for awhile but mostly just a lurker.... until now.

I have worked a lot on snowmobiles and Jetskis so I am not new to two strokes by any means.

My xplorer 400 has a tight bottom end. Tore it down and the crank and counter balance is toast. Looking for a source for rebuild / new crank etc. can’t seem to find a good source when searching. Any guidance in this rebuild would be helpful as well. First time doing anything but maintenance to this quad. I’ve owned since new.


Sent from my iPhone using Tapatalk

2018 Sportsman Front Brakes Dragging

I have a 2018 Sportsman 450 with 110 miles on it. On the last ride I noticed my front brakes began to squeal a bit. Now any time i roll the quad both front brakes squeal and have quite a bit of resistance when I attempt to free spin them. The vehicle is only 7 months old so hoping nothing too major to fix. Any suggestions?

Multi message display

Have a 2018 Can AM 570 XT, brochure says I should have a tachometer read out on the multi message display. A fellow rider has a '17 570 XT, tachometer screen shows up before or after the km/h screen. I have cycled through the menu several times but have yet to find the tachometer screen?

Any advice is appreciated.

thanks.

Registration issues and concerns.

Hello, I recently purchased a 2003 Raptor 660R. I went to DOL in Covington,WA. I applied for title. Etc. They sent me away with registration. A month sticker. And a year sticker (looks exactly like a car tab) Few weeks later. I get a green plate that says Washington restricted vehicle on top of it. With two spots for on road and off road tabs. My question is. How do I get an off road tab? This is my first off road vehicle in Washington state. So I'm not sure what I should do. Or who to contact. Or if I should just take what I've got to Moses lake and see what happens.

Predator 500 will start but have to hold hand over the carb.

Hey guys I have an 04 preddy 500,I'm having trouble getting it started 99% of the time. I HAVE to hold my hand over the carburetor until it spits back some gas then remove my hand and it tries to fire sometimes it will start up and run and other times I just have to repeat those steps. I've cleaned the carburetor thoroughly, put new piston rings in it, and a new choke cable and just cant figure it out. Would anybody know what it could be? I know I set the timing right, i have a sneaking suspicion it's the valves.

2001 Scrambler 400 Counter Balance Removal

Hey folks, does anyone have experience removing and replacing the counter balance?

My issues started with a water leak from the water pump. Pulled and replaced the pump and seals. Counter balance is too pitted to clean up and seal. The bike started leaking again.

I need to pull and repair or replace the counter balance.

Does the oil pump need to be removed? I've heard yes and no.

Can the counter balance be repair?

Does anyone have a link to a service manual with detailed instructions?

Thanks for the help!


Sent from my iPhone using Tapatalk

06 800 stumped

Have bike not working properly
I have new fuel pump tested 51lbs
New cam sensor
New maf,new plugs injectors both are good as I have switched from front to back no change . Good compression both cylinders and no engine codes or lights on. Start bike it idles for a few seconds then stalls hit switch starts back up I get the bike to idle but its rough as the rear cylinder isnt working I pull injector plug no change to engine. I checked pulse and it's good I had ignition analyzer and it's good. WTF? There is no reason the bike shouldnt be running. The valves have been adjusted and set now then I pull the plugs they are both white. When it's running it seems to hit and miss but the injection pulse stays active cant seem to figure this out. Any chance it's the speed sensor . Sounds stupid to me as I havent driven the bike in this condition. Not burning coolant and I've taken a propane torch without lighting it just turned gas on to check for a leak and nothing. This is a real head scratcher.

Sportsman 850 xp fender flares pics opinion

Hey guys I'm new to the forum and I have a 2014 polaris sportsman 850 xp on 29s and I have just mocked up my fender flares but I think they might rub. I haven't been able to ride yet and if hate to drill all the holes to find out later. Also not sure about the look? What do you guys think? I'm also running 1.5 inch spacers
Thanks

Attached Thumbnails
Click image for larger version

Name:	20190303_140550_1551668474120.jpg
Views:	N/A
Size:	3.88 MB
ID:	116299   Click image for larger version

Name:	20190303_140532_1551668492452.jpg
Views:	N/A
Size:	4.02 MB
ID:	116301   Click image for larger version

Name:	20190303_140507_1551668514187.jpg
Views:	N/A
Size:	3.50 MB
ID:	116303