Category: Forum News

Hey all,looking for a lockable tank cover for my Defender!

Can somebody give me a tip with that?

Bought a 2002 Xplorer 400 and getting it up to speed.. anyone know what type of oil to use in the injector, transmission oil and coolant? Does it have to be Polaris?
Thank you

Hello everyone. This is my first post. I just recently became a polaris owner and noticed a problem when cleaning it tonight. It rides and runs fine, and I recently did the first 25 hour service. When cleaning it tonight I noticed very slight bending and rust on the arms that lead to the tires. (Not sure what they are called) . We have only had this polaris for a few months and im wondering what could be causing this. It's only happening on the two front tires of the vehicle It's a 570-6 With a two inch lift on it with some msa's and 27 inch tires. Here is a picture.

https://imgur.com/a/SwxOYaK

Any help would be greatly appreciated.

Just checked, 7/8 on right, 1/2 on left. Time to adjust. Is 1/4 to 1/8 still called for on 2017 ACE 570, no dual struts? Thanks.

Hey guys, I’m trying to install a kfi winch on my 2011 500 ho. I have the winch on but the wiring has me confused. The electrical coming from the handlebar switch has the hookup for the wires on the contactor and I can do that, but it has a red wire coming out as well that obviously has to be connected to hot. I have 2 orange wires and a 4 hole connector that are pre wired under the handlebars. Do I hook the red into those? Or what the heck are they for?? Can I run an extender from the red wire to the red post on my contactor?

I am not mechanically inclined so please talk to me as if I’m 2. It’s probably the only way I will understand.


Thanks guys!!

Attached Thumbnails

   

I have replaced the starter, starter clutch, and battery, but will nit start. I pulled the starter out and spins fine, but when I put it in and hit the start button the solinoid just clicks, any idea what I need to do?

I just bought a 2016 sportsman 450 ho, the quad is almost brand new, only 1500 km on it. It ran great for a few days. We had a cold snap, minus 40 Celsius to be exact. Went to start it, it started just fine, sputtered a bit and died within a few seconds. Would continue to turn over, but would not start. It did start for about 5 seconds the next day, backfired and didn't run again. 3 days later and a fresh charge on the battery and it ran for a few seconds again, then died. Figured I would get a new battery, had to be the issue. Bought a new battery, charged it up to capacity. Installed it, and here we are, it wont start just keeps turning over. It has fresh gas, good spark plug. I have no idea where to go from here. (Note, lights and winch work no problem when quad is on).

Hey guys, just got a 2014 Renegade 1000 and brought it home today, didn't get much seat time on it but I was able to take it for a quick run, however I noticed that it seems to rev high for the speed its travelling, like 4000rpm and around 40-50kmh does that seem normal? It doesn't feel like the belt is slipping or anything, any input would be greatly appreciated!

Check engine light came on , just after starting. Machine was outside uncovered. this happened last year and the machine went into limp mode. took to the dealer and the throttle cable needed adjusting, a little slop in it.

seemed to run fine today.

i was able to pull the codes today. please help

Attached Thumbnails

   

Just picked up a 2018 highlifter 1000 Xp got a stupid question is it normal for reverse indicator to blink in reverse?