I have a 2010 renegade with a fairly new battery and it is giving me code P1656 and will not start. I have read it is DESS line shorted to ground. I have read every forum I could find on it and fixes include replacing battery, replacing ignition switch or replacing ECU. I will load test the battery tomorrow but has anyone had this issue and found the problem. There is not much info on it, but it seems to be a common problem.
Number of grease fittings?
because there is inaccurate information, here again the question how much fat nipple has the Defender Hd10 xt?
According to my information, I now come to 24 nipples, the drive shaft should have no and would be maintenance-free!
There are 8 nipples on the front A arms, 14 on the A arms and 2 on the back Sway bar !
According to my information, I now come to 24 nipples, the drive shaft should have no and would be maintenance-free!
There are 8 nipples on the front A arms, 14 on the A arms and 2 on the back Sway bar !
2019 Outlander Max XT – Speed
So just got my new 2019 Outy Max XT 850 and while driving it, on its first ride I noticed 5 to 45 mph comes quick. Off the top of my head, I would say 45 is about halfish throttle but when I pressed it further it just acted like it was being limited. I couldn't even get close to 50 mph. So basically is this normal or is my performance chip not programmed right?
Sent from my SM-N950U using Tapatalk
Sent from my SM-N950U using Tapatalk
2018 Can-Am Defender HD10 Max very high oil level?
Hello,
I have a 2018 Can-Am Defender hd10 which i bought last September (which i love!). i did the oil change at 600km with one of the 0w-40 full synthetic 500cc or more oil change kits which i bought from can am directly. when i poured the oil in I used all of the oil in and it was 3/4 way to the max mark after letting it run for 2 minutes with the new filter and oil. now at 1045 km i did a pre-ride inspection which i do every 250km ish and the oil was a good 2 inches above the max line!!! I have no idea why its like this. The oil isnt milky, cant smell gas and its not aerated at all. ive been driving it like this for at least 400km so im very worried.
(if you're wondering i let the motor run for 2 minutes after putting new oil in then checked it and was 3/4 to max when i did the oil change)
any ideas?
I have a 2018 Can-Am Defender hd10 which i bought last September (which i love!). i did the oil change at 600km with one of the 0w-40 full synthetic 500cc or more oil change kits which i bought from can am directly. when i poured the oil in I used all of the oil in and it was 3/4 way to the max mark after letting it run for 2 minutes with the new filter and oil. now at 1045 km i did a pre-ride inspection which i do every 250km ish and the oil was a good 2 inches above the max line!!! I have no idea why its like this. The oil isnt milky, cant smell gas and its not aerated at all. ive been driving it like this for at least 400km so im very worried.
(if you're wondering i let the motor run for 2 minutes after putting new oil in then checked it and was 3/4 to max when i did the oil change)
any ideas?
Doug from AZ
I’m a new member and have a question about a can am 200 rally atv. I am rebuilding my quad. I went to pull out the choke cable from the carb. I pulled the cable out but the plunger or whatever is supposed to be there is stuck. I tried WD 40 and heat with no luck. It appears that there is a lip inside that area that I can’t get the part up and out through. HELP
problems won’t stop
i guys, i have a problem with my outlander 650 2009, i start the atv but when a would stop with key or kill switch nothing the atv always run. i remove de ecu relay and the atv stop are you any idea wath is it ? sorry for my boring english ;)
Hello From Manitoba
Hello from Manitoba Canada! My wife and I bought a 2018 Outlander 650 Max XT in Fall and have been loving it so far! Tires, exhaust, and a few other goodies are starting to be installed, but the list keeps growing! PM me if your around the South East portion of the province and want to go for a ride!!
Eric
Eric
Hello from Western PA
Hello everyone. I recently bought my father a new Can-Am HD10 Cab model to keep in the woods with us hunting. I wanna keep up on everything happening with these machines and learn about the best accessories to install.
Will moving the handle bar back an inch or two help?
Put on 50 miles today but my back is killing me. Its a new bike (Max xt 1000) and my posture seems too ridged etc. Has any done this and did it help? it kinda feels like my reach is a little odd. im 6'1" 190.
thanks
thanks
Removing shocks
Hello all! I have a 2018 outlander dps 570 I’m getting ready to install some Elka Stage 3s. Does anybody have any information on the job? Is it as simple as it looks?