Ok I noticed tonight while greasing all the fittings that the front left side axle has some slip in it, not a lot .
The movement is not the joint and it’s not the shaft coming out of the front diff... it’s the yolk where it meets the splines in the shaft coming out of the diff.
Is there a set screw to hold the yolk tight to the shaft ?
If you grab the axle and pull it up and down you can see the yolk is a little sloppy on the shaft.
Seems like it’s only in one position.. so if it slips at 12:00 and 6:00 it doesn’t at 3 and 9... but if you rotate it then it’s at 3 and 8 and not at 12 and 6
Is this something you guys have seen before or am I being too anal
The movement is not the joint and it’s not the shaft coming out of the front diff... it’s the yolk where it meets the splines in the shaft coming out of the diff.
Is there a set screw to hold the yolk tight to the shaft ?
If you grab the axle and pull it up and down you can see the yolk is a little sloppy on the shaft.
Seems like it’s only in one position.. so if it slips at 12:00 and 6:00 it doesn’t at 3 and 9... but if you rotate it then it’s at 3 and 8 and not at 12 and 6
Is this something you guys have seen before or am I being too anal