Hi trying to help friend get his Sptsmn 500 atv going.. had no spark.. replaced Stator and coil... actually got it running, shut it off and wouldn't start again:( its rolls over but dosent try and catch/ fire unless you jiggle key or toggle key on of while rolling over... so replaced ignition switch and no difference same thing:( I'm at a loss now cdi? votage regulator? relay? fuses no idea??? is ther anywhere to find wiring diagram or how to test these.. or where do i begin help plz?
Get paid $300 for your opinion
MONDAY SEPTEMBER 17, 2018
PAID MARKET RESEARCH FOCUS GROUPS
We are organizing a series of paid focus groups in the Houston Texas area with owners of ROV (Recreational Off-Highway Vehicle). We are looking to speak with:
Men aged 22 to 65 years.
Those who are purchasers and owners of SSV/UTV/ATV
Purchased an SSV/UTV/ATV in 2018,2017,2016… or later
The group will last approximately 2 hours and all who participate will receive an incentive of $300 as thanks for their time.
Please contact Diane Peters at Decision Point Research for more information or to participate
Directly 1- 416-309-8856
Toll-Free 1- 866-700-3075
PAID MARKET RESEARCH FOCUS GROUPS
We are organizing a series of paid focus groups in the Houston Texas area with owners of ROV (Recreational Off-Highway Vehicle). We are looking to speak with:
Men aged 22 to 65 years.
Those who are purchasers and owners of SSV/UTV/ATV
Purchased an SSV/UTV/ATV in 2018,2017,2016… or later
The group will last approximately 2 hours and all who participate will receive an incentive of $300 as thanks for their time.
Please contact Diane Peters at Decision Point Research for more information or to participate
Directly 1- 416-309-8856
Toll-Free 1- 866-700-3075
2011 max 400 xt
I picked it up to just plow the driveway as it was cheap and like brand new. But the more we ride it the more we like it. I am used to bigger quads and in low and 4x4 she is just as good as any other. I’m just wondering if thinks interchange like a clutch like for the 500 or so on and so on. Also any advice on things to do first. Right now only upgrade is 26” rip saws
Get paid $300 for your opinion
MONDAY SEPTEMBER 17, 2018
PAID MARKET RESEARCH FOCUS GROUPS
We are organizing a series of paid focus groups in the Houston Texas area with owners of SSV/ATV/UTV, We are looking to speak with:
Men aged 22 to 65 years.
Purchased a SSV/ATV/UTV in 2018,2017,2016… or later
The group will last approximately 2 hours and all who participate will receive an incentive of $300 as thanks for their time.
Please contact Diane Peters at Decision Point Research for more information or to participate
Directly 1- 416-309-8856
Toll-Free 1- 866-700-3075
PAID MARKET RESEARCH FOCUS GROUPS
We are organizing a series of paid focus groups in the Houston Texas area with owners of SSV/ATV/UTV, We are looking to speak with:
Men aged 22 to 65 years.
Purchased a SSV/ATV/UTV in 2018,2017,2016… or later
The group will last approximately 2 hours and all who participate will receive an incentive of $300 as thanks for their time.
Please contact Diane Peters at Decision Point Research for more information or to participate
Directly 1- 416-309-8856
Toll-Free 1- 866-700-3075
brakes and bleeding issues
Can someone help here? This spring my front brake handle felt just a bit soft and braking on front got weak. Foot pedal which I understand does do a little of both front and back brake still worked well. I bled the lines (could there be a proper way to do it??) and no difference. To my knowledge there is no hole in the line and if there was wouldn't the symptom be that you squeeze front brake and it just goes completely soft on you? I can always maintain a little 'squeeze' in the handle and can pump it up to a higher pressure with a few rapid squeezes.
It sat most of the summer and when I tried again it again seemed to favor the front right tire and when you braked with front handle only it pulled over to the right while braking. I rebled the front lines again. The right front builds pressure and shoots a nice jet of brake fluid out every time. The left is inconsistent. One time good, then the next 3-4 times just a partial bleed. I thought maybe since the stream on bleed is weak that the bleeder isn't opening all the way and that may be part of the issue, but once it is closed again it shouldn't matter as long as it seals (and as long as there is no air in the system)
The rear bleeds fine.
It acts as if fluid goes slowly over to the front left brake caliper. What is the symptom of a line that is partially pinched or occluded? Are these lines flexible or rigid? Is there a usual pinch point if that is the problem? Does a bleeder actually go bad and have to be replaced outside of an obvious leak? I have no leaks underneath on the clean garage floor.
Is there a way to detect a tiny leak in the front squeeze handle or reservoir? I can't imagine a leak in the reservoir as then the right and rear brake wouldn't work well as they do.
But I'm looking to the pros. I had hoped by just moving a lot of brake fluid through the left line that would help but the behavior doesn't change, it just seems one out of 4 or 5 bleed attempts will give a good shot of fluid, the others a weak shot.
Thanks in advance!
It sat most of the summer and when I tried again it again seemed to favor the front right tire and when you braked with front handle only it pulled over to the right while braking. I rebled the front lines again. The right front builds pressure and shoots a nice jet of brake fluid out every time. The left is inconsistent. One time good, then the next 3-4 times just a partial bleed. I thought maybe since the stream on bleed is weak that the bleeder isn't opening all the way and that may be part of the issue, but once it is closed again it shouldn't matter as long as it seals (and as long as there is no air in the system)
The rear bleeds fine.
It acts as if fluid goes slowly over to the front left brake caliper. What is the symptom of a line that is partially pinched or occluded? Are these lines flexible or rigid? Is there a usual pinch point if that is the problem? Does a bleeder actually go bad and have to be replaced outside of an obvious leak? I have no leaks underneath on the clean garage floor.
Is there a way to detect a tiny leak in the front squeeze handle or reservoir? I can't imagine a leak in the reservoir as then the right and rear brake wouldn't work well as they do.
But I'm looking to the pros. I had hoped by just moving a lot of brake fluid through the left line that would help but the behavior doesn't change, it just seems one out of 4 or 5 bleed attempts will give a good shot of fluid, the others a weak shot.
Thanks in advance!
2002 Sportsman 500 leaking antifreeze
Mine started leaking saturday. Out of the blue. Fluid seemed to back up into the overflow bottle. Fan was working.
I couldn't see where it was leaking, is there a common area these normally leak?
I couldn't see where it was leaking, is there a common area these normally leak?
New to the Can-Am world
Hey Guys, brand new to the Can Am world, I've been a loyal Honda guy for anything power sports and equipment. After sitting on a rancher and seeing the price of a Rubicon, I moved over to a G2 chassis 2019 Outlander 650 XMR; better value in my opinion. I just picked the bike up two days ago, headed North next weekend.
Hello from Ontario!
Picked up my new to me,but used, 2013 renegade xxc 1000 the other day. 2” lift, wild boar bumper/rad relocate, snorkel kit, 2” lift, 29.5” swamp lites on SS rims, new 2500lb warn winch, this things a beast, took it out on one ride so far and hit a little mud patch and it took it like an absolute champ! Only issue I’m having at the moment is my high beams don’t work, yesterday they would work about 80% of the time, and sometimes would flicker when I switched them on, today, I get absolutely no high beams at all lol
New owner
Just picked up a 2011 renegade 500, 57hrs on it and 1,150km really clean machine.this is my first 4x4 quad I’m looking for some input on how often regular maintenance should be done and what ever else I need to know!
New member of the Can-Am family
Just joined the Can-Am family today. Purchased a 2018 Outlander 850 XT. What are some things I should know? I’ve ridden for years on trails, however this is my first ATV.