How many vent lines on 18 sportsman? SYA snorkel kit said 4 would be located below my top light but I only found 2....
Unknown hose
Hi guys i have a question, im in the process of restoring a 99 Scrambler 500.
And im trying to figure out what the hose is for just above the two oil lines coming from oil tank. The hose has a filter on it and ends by transmission without tying into anything . Is it just a vent ?
And im trying to figure out what the hose is for just above the two oil lines coming from oil tank. The hose has a filter on it and ends by transmission without tying into anything . Is it just a vent ?
Rear Shock Alternatives
I'm in need of a new rear shock for my 2004 Magnum 330 2x4 but being in the UK I'm finding it hard to get a new genuine one. I'm also struggling to find any info about which aftermarket replacements will fit.
Does anyone have any more info that might help me out?
Does anyone have any more info that might help me out?
2000 scrambler 500 idle issue
2000 4x4, cleaned carb, tank, etc. Adjusted pilot air/fuel. Idled well for the first two starts. Prior to doing that I could not get a good idle it was all over the place.
Now it starts easy and idles, after a few moments the idle starts to fall off. I raise the idle screw and it will idle for a while then start to fall off, if I do not give it gas it will stahl. Seems to run fine but just wont hold a steady idle.
Could this be fuel pump?
Now it starts easy and idles, after a few moments the idle starts to fall off. I raise the idle screw and it will idle for a while then start to fall off, if I do not give it gas it will stahl. Seems to run fine but just wont hold a steady idle.
Could this be fuel pump?
Sportsman Fuel Leak
Hi. I'm new to this forum. I have a 1999 Sportsman 500 I just bought. I found a couple gas leaks, and have one question regarding a connector or ???.
I see two devices, one of which is a filter, on one of the gas lines. The other line, comes from the "Res-Off-On" selector switch and runs to the carb. That line has a device in it, looks like white plastic, is about 1 1/4" long and slightly over 1/2" in diameter.(close to 17/32 or 9/16"). The filter, of course is larger. This device has a directional arrow on it, pointing in the direction of the carb.
Is it some type of check valve? It seems to be leaking at one end or the other. I don't know if the tubing is split or the device itself is cracked.
Anyone know what it is? I have to replace the switch, probably 3 pieces of tubing and the filter. I don't know about this other device. When I take it apart, I might be able to tell where it's leaking, too.
Thank you
Larry
I see two devices, one of which is a filter, on one of the gas lines. The other line, comes from the "Res-Off-On" selector switch and runs to the carb. That line has a device in it, looks like white plastic, is about 1 1/4" long and slightly over 1/2" in diameter.(close to 17/32 or 9/16"). The filter, of course is larger. This device has a directional arrow on it, pointing in the direction of the carb.
Is it some type of check valve? It seems to be leaking at one end or the other. I don't know if the tubing is split or the device itself is cracked.
Anyone know what it is? I have to replace the switch, probably 3 pieces of tubing and the filter. I don't know about this other device. When I take it apart, I might be able to tell where it's leaking, too.
Thank you
Larry
2005 Sportsman 500HO tire size question
I have a balding set of tires on my sportsman 500 HO quad sizes 26x8x12 on the front and 26x11x12 on the rear.
I found a great looking and priced set of tires on CL that are same size front but on the back it is 26x10x12.
Would this be ok or what kind of issues would this cause on the quad? Anyone know? Thanks in advance for the help and advice...
I found a great looking and priced set of tires on CL that are same size front but on the back it is 26x10x12.
Would this be ok or what kind of issues would this cause on the quad? Anyone know? Thanks in advance for the help and advice...
SATV power steering on a Magnum 500?
Hi, I bought some property and a '99 Magnum 500 came with it. It runs good but is hard to steer. With chronic tendonitis in both elbows I can't ride it much.
Has anyone added the SATV kit to a machine that old? and does it work good?
Thanks
Has anyone added the SATV kit to a machine that old? and does it work good?
Thanks
Magnum 500 service manual
Hi, I bought some property that came with a 1999 Magnum 500 and I am looking for a service manual.
Thanks
Thanks
polaris 335 camshaft
can anyone help I need a camshaft for a 335 sportsman 1999
2003 Scrambler 500 4×4 – Rear Shock Help
Hello all,
Trying to replace seals and O-rings on my Fox 1.5" ATV Series rear shock and cannot find any info on how much oil or even the process on how to fill it, etc. I have a local shop that can do the nitrogen, but wanted to save $200 and do the seals myself. Any good resources or advice would be truly appreciated!!
Thanks in advanced!
Daniel
Trying to replace seals and O-rings on my Fox 1.5" ATV Series rear shock and cannot find any info on how much oil or even the process on how to fill it, etc. I have a local shop that can do the nitrogen, but wanted to save $200 and do the seals myself. Any good resources or advice would be truly appreciated!!
Thanks in advanced!
Daniel