Hi my name is Peter i curently own a 2017 canam renegade 850 xxc I am in love with this machine it has 316 miles on it right now I’m definitely due for an oil change and other maintenance.
Canam renegade dash
I’m wondering how to put my name on the digital dash when I start my ATV. if anyone can help please reply
Interesting issue.
I have a 2015 Sportsman ETX just over 1000 miles. This year, I have been experiencing a weird issue. After riding/idling and the machine gets hot, it bogs when hitting the throttle and sometimes dies. I turn the key off and back on it starts right up and rides fine till I stop again.
Any ideas?
Any ideas?
Is this bad for engine?
Here is a picture of an engine we recently received at nFLOW Remanufactured Engines with a connecting rod that tried to exit through the oil filter casting! Give us a call for all of your engine, transmission and turbocharger reman needs! You can reach us at 812-402-8282. www.nflowmotorsports.com
Rusty water dripping from ATV
Hi everyone.
I have a 2012 Sportsman 800 and many times after I wash it off and it has been sitting around a few days, rusty water comes off it when I start moving it. I now think that the water is sitting in the two square frame posts that run from front to back just above the skid plate. They seem to be open ended and bent slightly upwards on the ends.
Does anyone else experience this? I have looked and can see no drain holes on the bottom of those square rails.
The other day I elevated the front end of the ATV and it has been dripping constantly from the back near the hitch where the rails end.
Thanks
I have a 2012 Sportsman 800 and many times after I wash it off and it has been sitting around a few days, rusty water comes off it when I start moving it. I now think that the water is sitting in the two square frame posts that run from front to back just above the skid plate. They seem to be open ended and bent slightly upwards on the ends.
Does anyone else experience this? I have looked and can see no drain holes on the bottom of those square rails.
The other day I elevated the front end of the ATV and it has been dripping constantly from the back near the hitch where the rails end.
Thanks
Stuck Clutch Cover Bolts
I've got a 1986 Trail Boss 250 that i'm starting a rebuild on - first time working on these Polaris ATVs. I'm trying to take off the PVT cover and some of the bolts just spin and spin. I assume the nuts embedded in the plastic cover are turning and the plastic has given out. For most of them I was able to get a tool in there to hold it enough so I could get the bolts out. But there is 1 bolt that has zero access to where the nut is (bottom back bolt).
Anyone else have this problem when trying to take off the clutch cover? I tried to drill it out but its too strong of a bolt and my drill out bits weren't making any progress. I'm about to take a hacksaw to it and just accept the fact I need to get a new one...
Anyone else have this problem when trying to take off the clutch cover? I tried to drill it out but its too strong of a bolt and my drill out bits weren't making any progress. I'm about to take a hacksaw to it and just accept the fact I need to get a new one...
2004 Polaris Sportsman 600 Twin Fuel tank
I'm trying to find a 2004 Sportsman 600 Fuel Tank. Can any one help in locating one that doesn't make me have to put down a second mortgage on my home?
Thanks
Thanks
Wheels (2008X2)
I need to replace my stock wheels (and tires as well). My problem is that I cannot go any wider at this time as my trailer is only 48" wide.
I could go with factory replacement (steel or cast) - but that's a rather pricey way too go for what you get. Note the cast wheel as the same as they used on 2009-2014 RZR I believe (Front p/n 1521106, Rear p/n 1521161).
I cannot locate any wheels with the factory offset (front 4+2, rear 6+2).
I have searched the forum but can't find anything that will point me to wheels that will keep my rear at factory width.
Suggestions?
I could go with factory replacement (steel or cast) - but that's a rather pricey way too go for what you get. Note the cast wheel as the same as they used on 2009-2014 RZR I believe (Front p/n 1521106, Rear p/n 1521161).
I cannot locate any wheels with the factory offset (front 4+2, rear 6+2).
I have searched the forum but can't find anything that will point me to wheels that will keep my rear at factory width.
Suggestions?
2015 Sportsman 570
2015 Polaris Sportsman 570
-1,100 miles. 129 hours, front brush guard, hand guards, mirrors, heated hand grips and thumb throttle, led light bar, led headlights, Polaris rear box, rear Polaris “tough rack, next to new 8 ply Kenda tires, 2500lb Polaris winch, 60in warn snowplow. Rear Work lights. In very good condition, runs and rides great. Only selling due to purchasing a side by side so no longer needed. Original owner. Asking $4,900 OBO 570-401-9298
-1,100 miles. 129 hours, front brush guard, hand guards, mirrors, heated hand grips and thumb throttle, led light bar, led headlights, Polaris rear box, rear Polaris “tough rack, next to new 8 ply Kenda tires, 2500lb Polaris winch, 60in warn snowplow. Rear Work lights. In very good condition, runs and rides great. Only selling due to purchasing a side by side so no longer needed. Original owner. Asking $4,900 OBO 570-401-9298
2002 bombadier rotex 4×4 650 unknown part need help please
Ok unsure how this site works just put this on just pissed me off too. But I need all the help I can get PLEASE!!! SUMMER is play time for me and my two kids when they r not with there dad.
Ok I have a black box that goes below my starter selonid has 2 wires coming out the back one goes to a ground nut other one unsure if goes to starter selonid or battery. My push button starter works when it wants 2 so was using a screw driver on selonid to start it. Well this time it burned a few wires and I can't find this part anywhere and trust me I have looked also my bombadier has a Warn wench, if that matters. I may be a female but I'm good well ok with fixing thing tkx 2 internet and u tube. Anyways I need help please. Attached pic of mystery black box pain in my ass
Ok I have a black box that goes below my starter selonid has 2 wires coming out the back one goes to a ground nut other one unsure if goes to starter selonid or battery. My push button starter works when it wants 2 so was using a screw driver on selonid to start it. Well this time it burned a few wires and I can't find this part anywhere and trust me I have looked also my bombadier has a Warn wench, if that matters. I may be a female but I'm good well ok with fixing thing tkx 2 internet and u tube. Anyways I need help please. Attached pic of mystery black box pain in my ass