Category: Forum News

I have a 2011 Outlander Max, last week the throttle stuck wide open in the yard and the bike took front end damage.

I took the front plastic off today and as far as I can tell the frame itself doesn't appear to have any damage, but the bumper, facia support, and upper rad support were bent. I also noticed the top engine mount (that bolts to the front cylinder) has broken and stretched, and the intake has shifted just enough to pull the boot off the air box.

I ran out of daylight taking it apart today, but the front bottom engine mount looks fine. I'm just wondering if anyone has seen this before, and if I should be looking closer at the frame for a bend, or the motor mounts.

Thanks!

1992 trail boss will only start after jumping the solenoid located by battery this happen after sitting for the winter I replace the solenoid the relay CDI box ignition switch stop button switch don't know what to do next

Im in the Indianapolis area. Willing to drive about 4 hours to purchase one

Who has the best prices.?

Sent from my SM-G955U using Tapatalk

I have a 2007 sportsman 800 efi , took the pump unit out of the tank and my float is soaked . Was curious how you guys put the new float on? I had read when I looked up on google there was a sticky number 10 that has a how to on here but can’t seam to find it ... any help is greatly appreciated .theres a photo of my pump with the float as well

Attached Thumbnails

 

has anyone had to replace there shock bushings where the bolt goes through on a scrambler if is there aftermarket bushings

I have a 2002 Polaris ranger 500 4x4 solid rear axle, it also has the manual turf mode lever not a switch. I can’t get the turf mode to engage. Ive put new bearings and seals in the rear diff, put a new axle on the left rear, and have adjusted the turf mode cable according to the repair manual. But still no luck with getting the left rear to lock in and pull, only the right rear pulls. Anyone know what else to be checking for? Thanks!

I have a 2002 Polaris ranger 500 4x4 solid rear axle, it also has the manual turf mode lever not a switch. I can’t get the turf mode to engage, put new bearings and seals in the rear diff, put a new axle on the left rear, and have adjusted the turf mode cable according to the repair manual. But still no luck with getting the left rear to lock in. Anyone know what else to be checking for? Thanks!

Im thinking of trying to making a snorkel for my 2007 renegade. Any tips or advice?
Much appreciated

Sent from my SM-G930F using Tapatalk

I have a 2016 XP4 1000. Will the 29x11 rear wheels fit on the front. Have a chance to buy a rear pair for $50. Would like to have the same size tire all around.

Picked up another sportsman yesterday. Wasn’t really looking for one but I couldn’t pass it up. 2008 800 ho efi with the maroon paint and only 670 miles on it. Came with a Polaris plow and 2,500 winch. Not a scratch on it, looks like it just left the showroom floor. Only gave 3,500 for it so I’m happy and it looks good sitting in the garage next to the 850 sportsman