Solutions to fill holes in front Rack

Unless I am missing some caps or something on my Outtie, the verticalish tubes on the front bumper that extend almost up to the front rack are completely open on top. It doesn't seem like there are any drain holes so I assume the bumper would be good at holding water. What is everyone doing for this? Is it fine as is? Should I drill a few drain holes in the bottom?

TIA

Polaris sportsman 500 6×6 04 2 front wheels 2 inches out of line

My polaris sportsman 500 6x6 04! I put 2 new tyres on,bearclaw 25x10x12 on last week. I noticed that the right hand side wheel is rubbing against the mudguard and the left had side is perfect! Upon inspection I cannot see anything bent except an ever so slight dent in my a bar? What is my problem? Any help much appreciated

Soundbar mounted to handlebars?

I have a 2018 renegade xmr 1000 and I’m looking to mount my Wet Sounds stealth 6 soundbar to my handlebars because I don’t have another place I can mount it to right now. If anyone has theirs mounted to their handlebars, can you tell me the hardware you used to mount it?

one last clutch question

I picked up a non ebs clutch and put it on my 2003 sportsman 500 and used the 3211069 stock belt.

It feels better with the new clutch and engages a little quicker than the ebs clutch did.

The only thing I noticed is that the atv creeps forward on it's own very slowly when I have it in low, otherwise it seems fine.

I don't mind the creeping, but is it causing any added stress to anything or could it cause other parts to fail earlier than using a longer belt (3211077) would?

Sorry for all the clutch questions lately, I just want to give this atv every chance I can to stay healthy for as long as possible.

Thanks,

New to group

Thank you for the addition. I have a 2013 renegade 1000. Qsc primary, stm secondary, 1020 kit with mag+ cams

2006 predator 50 no start

I have a 2006 pred50 that was in storage for a year and now won't start , turns over has fuel and spark the red light on dash does not come on when you turn key on

2016 outlander maxxt

I've got a practically new ATV that has less than 50 hours on it. I rode it yesterday for about 30 minutes, parked it, tried to get back on and it wouldnt crank. Still wont crank. If you turn the key, itll turn over but it will shut right off. Then it wont even do that until you give it a few minutes. It's never gave us issues and even started and ran fine yesterday for the 30 min I was on it. Any ideas??