Category: Forum News

Hello. I just changed my belt out on my 500 and was giving the bike a few revs to insure everything was good. Not even a second later the clutch exploded nearly taking my arm off. I don’t know what kind of clutch I need of it. I can’t find the vin anywhere. Please help

So put on new carb and new correct Jets and everything is running great but leaks a little gas out bottom of carb only when running. I adjusted float by pushing down on float tab but still does this. Any ideas?

I have a 1997 Sportsman 500 and it starts right up and runs good but after 30-35 minutes, I have never timed it it just up and quits. First time it was out of fuel, so I thought nothing of it but it continues to do it.

I use it to plow snow and it takes about 35-45 minutes to plow it all off and I never quite get it done before it quits. Let it set 30 minutes or so and boom fires right off and runs.

I replaced the ignition coil with a brand new one and still does it.

Seems to me to be electrical related and something gets hot and it quits, once it cools life is good. Engine is full of oil, full of coolant.

Any ideas?

Jeff

2000 Polaris 500 Sportsman

Installed a new cheap e-bay carb because slide in original carb would not rise. New carb is running great except that bike is idling too fast even with idle screw backed out all the way. Wondering if main jet could be too large, it is not marked, or should I check to see where pilot screw is set. Not sure whether it is plugged or not. I think it is supposed to be backed out 2 5/8 turns from seated. Thanks, Hoot

Now that I have fixed the voltage issues, I need to replace all the bulbs. Does anyone know how to replace the bulbs in the low beams (two lights in the front brush guard). Wondering if I need to take the entire reflective backing out of the housing to get to the bulbs. Any bulb number would be great.

Thanks

Was in a dealership checking out atv’s and Just happened to see a used 2013 camo 1000 XMR Outlander in amazing condition, I thought at first glance it was brand new! It looked so bad ass I couldn’t resist and came home with it! I’ve added the passenger seat with the back cargo box and just put on the Yoshimura slip on, love that sound! I’ve had it about 2 months now and I love it, but with the warmer weather coming should I get some type of fuel pack or tuner for the pipe, I’m hearing off this site that this ATV runs pretty hot? Also looks like acs has been disconnected and I’m seeing a set of 4 piggy back Elka shocks which a couple people from this site said should be a bonus and a step up from stock suspension, just not sure what stage they are! I’ll add a picture of them just in case anyone might have the same ones! Great forum lots of good reads, see ya on the trails!:-)

Attached Images

File Type: jpeg	EC4402E5-5184-4FD1-9D0C-3825291C25D7_1522500498060.jpeg (954.6 KB)
File Type: jpeg	9A873A87-0EF1-4447-B23B-4B105574A59C_1522500520451.jpeg (2.06 MB)
File Type: jpeg	9077F733-5962-4F23-A150-5B1248C75BE5_1522500564184.jpeg (1.38 MB)

So my 2017 Can am went to limp mode when I was idling in water that was just to the bottom of the exhaust tip. No deeper and it wasn’t under water. Any ideas?

hello
can any one tell me where to place a solenoid on my 2018 sportsman xp 1000
and could you send picture of location...
thankis

any one know where i can find some 12x7 (5+2) wheels? i went to order some Quadboss wheels which are available with this offset, only to find they had done some sort of massive recoil and were reworking the wheel.

i have a Polaris 2018 Ace 570 and im looking to replace the factory wheels without increasing my width.

thank you
-Matt

D2 hit a homerun on the xp overfenders! Fast shipping, perfect fit, clear and simple instructions, easy install, plenty of quality hardware and they look WAY better than the OEM's with lots of coverage for the stock and wider tires. For the quality, fit and finish they're actually pretty reasonably priced too.
Way to go D2! :fing02: