Hi I’m a newbie just saying hi I just got my second can am a defender XTP HD10 and love it. I Sold my Kubota RTV and my outlander 800R for the 2018 defender.
Heated Grips Overheating ’09 Sportsman X 850
Heated Grips overheating. 2009 Sportsman 850 XP Browning Edition. Getting 13 volts to grip on right side with switch off. (both switches test good w/ meter) Also getting 4 volts to left side grip with switch off. ( separate switches for each grip ) Can anyone tell me where to find what control's the voltage to the grips ? I think this is where the problem lies.
Thanks in advance. Lakeman007
all wires are good in the headlight pod. resistor or diode ??? where is it located ?
Thanks in advance. Lakeman007
all wires are good in the headlight pod. resistor or diode ??? where is it located ?
Need motor
Have 2013 sportsman 800efi, where is the best place for a rebuilt motor, or rebuild kit
new to me 2006 sportsman 500 having issues
Bought this quad in october of 2017 added a snow plow and have only used it plowing my driveway. After a couple of snow storms the check engine light came on for awhile, then went out. Used it again and the check engine light did the same thing. Last week the check engine light came on and has stayed on since. Read the owners manual about fault codes, and can't get it to do anything. turn the key 3 times in 5 sec produces nothing, holding the mode switch in and turning key on will let me scroll through trip, miles, battery voltage, sometimes it won't do anything. No fault codes. Thought maybe running the engine would allow me to do something, got nothing there either. Went out today to play with it and it would turn over but wouldn't start. Now I'm pissed. Can someone help, thanks.
2008 Outlander 500 XT Mud Guards or Fender Flairs
Does anyone know what the BRP part number is for these?
2018 Renegade Xmr 1000 Handlebars have play
My 2018 Xmr 1000 has play in the handlebars about 1/4" left to right. I have checked tie rod ends, A arms, tie rods everything is tight. No play in wheel bearings(12/6)(3/9). I have looked at DPS it looks fine nothing loose, Pit-man looks great. Any one had this problem?:th_smiliefrustrated
new from michigan
bought a 2006 sportsman 500 efi in october and starting to have issues with it.
April 21 SNIRT Run, Tug Hill NY
All weather event, usually very well attended. Trails open a couple weeks early for the SNIRT run. See Barnes Corner's Sno Pals website for info.
If there is little snow left at that time, there will be a few thousand machines on the trails. If there is much snow there will be less, but they usually open up the roads for the event in case the trails are too bad to navigate.
If there is little snow left at that time, there will be a few thousand machines on the trails. If there is much snow there will be less, but they usually open up the roads for the event in case the trails are too bad to navigate.
Front output shaft seal for 11 outlander
I'm needing help finding the front output shaft seal where the shaft comes out of motor I've been looking at this one diagram but I can figure out if I'm looking at the wrong one or not but he diagram im posting is that the shaft that goes all the way through the motor and is the seals that I need in this diagram
Rhino axle cv joint rebuild??
Alright guys I have a 2011 outlander 800 with a 4 in super atv lift with rhino axles my question is I broke the outer cv joint on rear passenger side and was wondering has anyone ever replaced just the cv joints on these rhinos??? And my next question is what are you guys opinions on rhino axles and what axles do you guy recommend running with the 4 in super atv lift thanks