So today while out riding with a friend his rear intermediate shaft came out and caused the rear output shaft to bend. Has anyone ever seen this happen and possibly know what would cause it. It’s a 2013 outlander 800 xtp


Sent from my iPhone using Tapatalk

It's been quite a while since I had an atv... 2001 when I sold it. I'm a fan of BRP and currently have four of their sleds. I'm convinced that the Outlander is my next purchase (two actually, the wife needs a ride also). I wanted to become a member now so I can spend a little time with ya'll and see what's going on in the Can Am world. Happy to be aboard!

I took the atv for a ride today (5-6 minutes) and when I parked it the atv wouldn't start back up.. it makes a clicking noise instead of cranking and the atv is giving off 2 codes: 520230 31, and 520193 7

Any help will be appreciated

I took the atv for a ride today (5-6 minutes) and when I parked it the atv wouldn't start back up.. it makes a clicking noise instead of cranking and the atv is giving off 2 codes: 520230 31, and 520193 7

Any help will be appreciated

HI any one having trouble with 2016 450l outlander starter drive not working when cold only 450 miles dealer put new drive on same thing

Can someone help explain where the circuit breaker is on a 2015 Polaris Sportsman 570 SP with EPS.

I lost power to the pod due to a battery short circuit and the manual says to reset the circuit breaker.....any help in explaining its location or a video demonstration would be appareciated!

Katylady99

Sent from my SM-G930V using Tapatalk

Tough start to my first Polaris experience. Dealer sells me a wheel tire package and one hour onto my first ride and one tire turns out to have an issue. It won't seal and hold air. So now as I am loading up for an all day ride tomorrow with my boys I start the machine just to find gas pouring put the bottom. Only 4 hrs on the thing at this point. A few minutes of looking finds fuel spraying out at the top of the tank. I can't tell if this is the fitting or something else right there. Has anyone else had this issue?

Had a freak accident and was trying to think of ways to prevent it from happening again.

A trail I normally ride on was blocked by a huge fallen tree. I was going around the tree and a vine grabbed my thumb throttle.
I took off like a rocket plowing through brush until I ran up a tree sideways and it flipped me.
Broke several ribs, banged up both legs and bruised me up pretty bad.

I understand if I was more careful this should not happen. BUT it did and I've been out of commission for close to a week. Highliter is unscathed.

I'm installing a lanyard kill switch and was curious if they make a bar that would block the throttle. Friend of mine installed a twist throttle on his but I don't like that idea.

Any ideas? Anyone else had this happen??

Attached Thumbnails