I am thinking of changing the springs in my clutch Just needing some input from people that have done it
Looking at epi primary and secondary springs. What do you recommend. Running stock tires Just want more torque to make it easier to wheelie mostly in water. Yes I know it's a longer framed wheeler Not looking to get into that debate
Just asking what is too much of a change and what is just right Maybe just state what pound spring works best. Thanks

Having problems and I think it's the secondary binding.

Going down a big road at a steady pace, if bike gets unloaded from a dip in road, you can feel a definite upshift and easier going.

Hold it wide open hits 106 and hits a wall. Hold it there a few seconds and it will eventually pull through like you hit it with nitrous.

Had it apart the other day. Helix worn into sliding half quite a bit. Some wear or contact on sliding half where the two half's meet.

Fixes? Bushings? Aftermarket bushing sources?

You can buy an stm for what they want for the sliding half.

12 700 kms on bike.

I've got a 2007 renagade 800 I've changed fule pumps to fix a miss that occurres during high rmp kicks the bike into limp mode changed the pump now the mid is back not the limp mode the display runs a h then some numbers across the screen quickly that's all I know i have no p codes I have no clue

I think I need to clean my K & N air cleaner in my 2007 Sportsman 450. However I am not sure. It is black but not too sooty or worn. I drive constantly in dusty dirt roads and would expect the air cleaner to be brown, but it is dark black. Is it ok, or should it be cleaned?

Hi. I plan on selling my 98 Sportsman 500 and buying a new 570. It looks like some incentives just expired. Best i can find one now for us $5800 out the door. Should I wait or is that good? Located in SW Pa.

Thank you

Hey everyone, looking for replacement lateral side panels for my 2017 570 outlander XMR. wanting to change the white panels to black but cant find anywhere that has them. can anyone shoot me in the right direction or know of anywhere that would possibly have some?

For years I have been working on my machines and those of friends on the floor. I put them up on snowmobile skates and lock the brakes. That got them up off the floor a bit and allowed me to move them around wherever I needed. I could work sitting on a roller seat and I was perfectly happy.......I do some part time work for a local dealership. Mostly assembly of new SxS and deliveries but I do some service work too when the shop gets backed up. Started using a table lift there and got spoiled. So I did some research, saved some money and bought one. Brand is Derek Weaver, it was less than $1000 including shipping.

Attached Thumbnails