Author: Forum News

Hi Everyone!

Nice to be a part of these forums. I have a 2009 Outlander 500 Max XT.

Great ride, but unfortunately I don't ride it enough so I am probably going to sell it. :(

I own a Polaris 400 Sportsman. When I try the electric start for the 1st try, it will try to start for a second but will not. After the second, you will here a clicking sound from the rear. I will turn the key once again, no sound like it is trying to turn over but the clicking sound will happen from the rear once again. I am able to start it with the pull start though. I have charged the battery and the battery is within 2 years old. In addition, before I charged the battery yesterday, I would attempt to start it with the pull start and the battery light on the display would blink and the dial on the speedometer would turn red. After I charged the battery yesterday and started it today with the pull start, it did not blink. Is the problem just the solenoid or something else? Thank you

Hi everyone I have a 250 polaris trailblazer I have been riding it about everyday for the past 6months. I went for a 7 mile ride one morning parked it then about an hour later drove it again. Only this time it seemed like by the time it got warm it shuts right down. If I wait a few minutes it'll start right up. And I can ride for about 20 minutes and it shuts down again. It starts up first turn of the key every time what could this be

I have a 1997 polaris Sportsman 500 and was wondering what I needed to preform a proper HO update. I heard all you need is a camshaft from an HO and an HO carb. Will the carb fit with the boots and hoses currently on my non HO?

So i have posted a couple times on the maint. and repair forum on this site, but not getting much help, I have a 2003 sportsman 700 that is getting coolant in the oil. found the problem to be the rubber sided washer behind the impeller for the water pump was installed incorrectly,question is can i just replace the rubber coated washer or do i need to replace the seals in the water pump again. Going to put a new impeller in it to seems how the plastic one got chewed up a bit from the washer being installed incorrectly, going to go with a machined aluminum instead of plastic now. second question is how hard is it to rebuild the primary clutch on this particular machine? I can get the rebuild kit for the clutch for under $200.00 online. Cant find a rebuilt one for it anywhere. Thanks for any and all help....Bob

Just wondering how hard it is to rebuild the primary clutch on this machine? can get the kit to do it online for under $200.00 and cant find a rebuilt one for it anywhere...thanks for any and all help. Bob