Posted on

2015 Outlander 650 temp sensor

Anybody ever cross reference a temp sensor OEM# 278 002 895?


I found saying Bosch 0281002209 or Zexel 479799-3520 but haven't found an auto parts store that has these numbers


Any help would be greatly appreciative!
Posted on

06 sportsman bulbs

hey
just wondering if anyone has replaced the factory bulbs with plug and play newer ones
I'd like to put in something alittle brighter without going to light bars and such. silvania bubs if possible. I read that it may be a H4 bulb but can't comfirm.
thanks
Glenn.
Posted on

Front drive shaft removal XP1000

Serviced my 2017 1000 and discovered that the front U-joint on the front drive shaft is junk. The 1000 has 840 miles on it and I am disappointed to find the bad u-joint.

My question is, to remove the drive shaft is it as easy as knocking out the roll pin on the front pinion and then sliding the shaft towards the rear enough to get the front yoke off of the shaft?

Thanks in advance, that is what it looks like to me. I have had several Polaris machines and this is the first U-joint that has failed.
Posted on

Need help

1995 trail boss head gasket blew my trusty mechanic will be doing the repair I’m looking online for replacement parts but not exactly sure what to look for when it comes to companies descriptions on what my package will or should consist of. I’m not sure if that makes sense I just want to make sure I get the right part
Posted on

What are these wires for?

About a year ago I smelled smoke from under the seat of my 2010 Outlander 800R. A triple connector connecting three heavy yellow wires was melting. One side of the connector could not be saved so I cut off the remains and put three separate connectors on to replace that side. Now a year later it is smoking and melting again after the engine has been running for a few minutes. I have the circuit diagram but I can't be sure what the three wires are and if they should be drawing such heavy current. Can anyone tell be what these wire are for?
Ignore the battery below the connector in the picture. I had trouble finding a small battery to replace the original so I made a new bracket in the empty space below the engine and fitted a small car battery. It is much more convenient to access it.

Attached Images
File Type: jpg IMG_1817.jpg (102.6 KB)
Posted on

Scrambler 850 high idle

Hi guys, does anyone have an issue with their bike idling so high? It will go over 3k rpm then it will go into safety mode stuttering. After it cooled off it strated normally idled ok for 30 seconds and started to go up again. Please help!

2014 Scrambler 850xp h.o.