Posted on

Identify these tires:

https://tricities.craigslist.org/snw/6581225453.html

These seem like a good deal based on appearance best I can tell.

He says they are for a Polaris RZR. I have no idea if they have the same bolt pattern as an Xplorer 300 or Magnum 425. Anyone know if the bolt pattern and offset would be compatible with my two quads?

$55 a piece for wheels and fairly new tires. I'm in the market for some "better" tires and wheels, if not for my 97 Xplorer 300 but my Magnum 425 I'm going to be refurbishing. That quad needs the rims sandblasted which would cost about $15 to $20 a piece just to have sandblasted and I have some used tires to go on it but they are not in the best shape. Tread is good but the rubber is a bit cracked for dry rot. Definitely not something I would want to run on a car but might be OK for the trail but may affect grip.

What do you guys think?

Just wanted some advice if you were in the market would you buy these?
Posted on

Poll: What’s Your Opinion of the Nikola NZT Electric UTV?

Poll: What’s Your Opinion of the Nikola NZT Electric UTV? Poll: What’s Your Opinion of the Nikola NZT Electric UTV?
If you’ve been following the development of the Nikola NZT electric UTV from Nokola Motor Company then you likely know the opinions of it are as varied and colorful as the people sharing them. Some people appear to be intrigued while others are quite skeptical. Other than a couple of journalists from electronic/tech publications, it doesn’t appear […] more
Posted on

Sportsman 450 eps battery voltage

Rode new 2018 Sportsman 450 with eps for 4 hrs, power steering stopped working, low battery warning came on. Dealer gave me new battery, starts off with 12.4 volts rode for an hour and voltage goes between 11.8 and 12, what should it be? I’m concerned it’s the charging system not the battery.
Posted on

Sportsman 450 eps battery voltage

Rode new 2018 Sportsman 450 with eps for 4 hrs, power steering stopped working, low battery warning came on. Dealer gave me new battery, starts off with 12.4 volts rode for an hour and voltage goes between 11.8 and 12, what should it be? I’m concerned it’s the charging system not the battery.
Posted on

NPP Supernasty tuner???

I just installed a Supernasty Slip on exhaust on my 2015 XMR 1000 Outlander and wondering what everyone out there recommends for these exhaust as far as a tuner???

And how are they to setup?

Thanks..
Posted on

1986 trailboss stator ohm resistance

Hello new member here. Picked up a trailblazer 250 with no spark.

I am having trouble finding the ohm resistance for the stator. Mine is coming in at 22.7. I assume this number will be able to help me but without knowing the spec it's hard to tell. Lol. Anyway I will be tracking down a manual for it soon but looking to get this thing up and going.

Any help is greatly appreciated. I've searched a lot of places and can not find the answer. Thank.
Posted on

Squeaky Wheel

My 2017 Sportsman 450 seems to have a minor squeak from the front right wheel. It kind of is a wagon wheel squeak where as it rolls there is a spot where the squeak happens and it is quiet for the rest of the revolution. I only have 100 hours on it and have run through some water but nothing extreme. Should I just get ready to replace bearings or is it just something that needs grease?
Posted on

Carb Needle Setting

So I'm rebuilding the Carbs on my GF's fathers quads. One is a 2006 Scrambler 500, another is a 2000 Xplorere 250, and a 2000 Trail Blazer 250. What is the factory Needle E Clip Setting? I have looked at the service manuals for each and none of them reference the factory setting.

Thanks,