Author: Forum News

Headlights on my 2010 Sportsman 500 not working. The switch works. I tested it out on my 400 sportsman. The voltage on the black wire coming into the switch is 4.8v and it should be 12v. The yellow wire is 0v when on high beam. Why is there not 12V coming into the switch. The other half of the switch works - on/off and reverse. Is there a voltage regulator issue? I'm stumped. Any where else to check?
I attached a picture of the wire connector I'm using to test the voltage. I pulled out the shim to allow my volt meter probe to get at the wires.
Thanks in advance!

Attached Thumbnails

 

Hi folks,

I've been trying to locate the thermostat on my bike and not having any luck, the one place I was told it was, by a friend, wasn't right. I've checked the manual I bought through this site a while back, and they don't mention one.

Is it possible to not have one?

If there is, can someone please steer me in the right direction, pictures would be great!!!

Thanks for any and all assistance.

Has anyone tried putting a 2” lift kit from high lifter on a 2018 sportsman 850sp?. I called high lifter and they said the kit for the 1000 will probably fit but they haven’t tried it on the new 850 so they weren’t positive...

Hey guys,

Background first... My daughters Predator, would die after it got hot. So from past experience, I have seen the stator go out. So I replaced the stator and the coil. And its still the same. When I hit the starter, I get a single spark at the plug and that's it. The only thing left could be the CDI Box I am thinking.

Now searching for a CDI, I find a Polaris ones for $175+ and aftermarket for $15+

What worries me is that the aftermarket ones have an extra blue wire coming out of the bottom. Anyone know what that is for? I called and emailed sellers of these cdi's and non of them can tell me what it is for. They only say that's the way they get them.

Help Please!!

Thanks,

Jess

All,

I have had some issues with my carburated 2005 ATP 500 stalling out while idling it only has 350 miles on it and sat around a lot when the previous owner had it, it idle's normally between 900-1100 rpm's but will drop below and stall out.. I'm going to pull the carburetor off and clean it.

While I have it off Should I install a Dynojet kit? or is there anything else that is better/ worth doing?

I am looking at an 2013 Outlander Max XT 400. I have tried doing my due diligence in researching the different manufacturers and models in the price range I want to stay in. I like the idea of a 2-up machine as I have a son who wants to follow me everywhere. Is there anything to shy away from on this model?

Thanks in advance!

I am looking for part number 711267270 (number supercedes to 420267270) a flange rubber. This part has been discontinued by CanAm and John Deere. Anyone have one laying around....new or good used one? Thanks for your help!!