Posted on

Highlifter Forward A-Arms

For Sale... Highlifter Front Arched Forward A-Arms, Black with all 4 Keller Ball Joints, Garage Products Bushings….. A-Arms cost - $410, Keller Ball Joints - $534, Garage Products Bushings - $110 ($1058 total) - sell $600 plus shipping, these are off my 2016 XT and will work on all years standard width machines.. (will not work on XMR or Cab Models)
Posted on

work.eco/normal mode switch



Hello:

I see some defenders have this switch and some do not. I have the 2018 XT-P model and it does not, is this switch an option??? I do not understand why all of the Defenders don't have this switch.
kenner
Posted on

Remove decompression lever

So, quick question,hope someone has experience doing this...

Want to remove decompression lever on 2013 400xt...There all the same..

#1 When you remove the cam bolt is the cam gear notched and will it stay in place or fall down...

#2 When you remove cam bolt, outer metal plate and spring and lever it leaves the Deko rod that goes through gear into cam shaft,can the shaft just be pulled out or does cam gear need removing...

I have searched high and low for the answer to no avail,hope to find some help here...


Darn near everyone started on a 400 someone must of removed the noisy POS...TIA
Posted on

Polaris scrambler 04 will not wheelie

I have a 04 scrambler. 4x4 and RWD. it has a winch in the front. Ive tried all types of ways to wheelie it and nothing works. Can i wheelie a scrambler or what the heck. Ive put my left foot on the rear rack, ive pushed my body back. Ive pressed the brake while revving it. Any tips?
Posted on

Regrease?

I just puchase a new 2016 scrambler 1000. Yes its a new left over. After my second ride i noticed the grease running out of the rear a arms by the rear end housing(see picture). The housing was warm but not hot after a 100 mile ride. Should i regrease it now with high temp grease?

Sent from my SM-G950U using Tapatalk