News

Ok I know what you guys are going to say... "don't drive it on the pavement..."

BUT, here in Idaho, you run into the occasional country road so you get on their and haul ass to get to the next trail head. So, at around 35-40 MPH on pavement only, I start getting wobbles in the steering column. Could it be the EPS...? Kind of tripping me out cause on dirt there are no issues.


Thanks for the insight!

I have been having issues and not sure where to start. So I started with the fuel gauge and had issues with it running for 15 mins then started dieing.

Attached Images

File Type: jpg

20180710_183913_1531276833637.jpg (2.87 MB)

Hi there, recently purchased Can Am Outlander which I ride in New Zealand

While cleaning my Outlander I noticed a clear plastic tube hanging down behind right front wheel. Any ideas what this tube does?

While cleaning my Outlander I noticed a clear plastic tube hanging down behind right front wheel. Any ideas what this tube does?

So , my machine had 80psi compression. After rebuild I have 90 psi . I ran it for about 20min lightly around after rebuild . First time I have ever opened a motor .

Alot of smoke and I hear a metal sound . I did not have it honed or bored as I was told after I took it in the cylinder was fine .

What next?

Is there a difference between a 2018 Sportsman 570 ATV and a 2018 Sportsman 570 Tractor?

i have a 2015 xmr 800 outlander. i dont use it much as it only has 50 hours on the bike. the bike began to stumble under high speed/load. figured was bad gas. used all gas put fresh gas in it with no help. one day using it to move boat around yard it just died. wouldn't start. i changed the fuel pump. (dont see a fuel filter appears just run from pump to two injectors. now it will sporadically/randomly start but wont stay running more than 15 seconds or so. i can give it some gas and it stumble but eventually die. check all fuses and are good. pulled plugs checked for spark and have spark.

what could my issue be? open to all ideas at this point

I Have a 03 sportsman 600 it starts right up cold and drives good but when it gets warmed up it gets boggy and has no power. Also when it's warmed up I have to give it a little throttle to get it to start. There is no lights on and it only gets up to about 200° according to my temp gun. Today I cleaned the carb and the fuel pump but still have the same issue, I also check the fuel filter. Checked the intake boot and the vacuum line for the fuel pump I didn't see any cracks or anything. Its got new plus and a new stock exhaust. Any ideas?