News

I have a 2000 scrambler 500 4x4 that runs like a top but the transmission took a serious blow. not exactly sure what happened but I was railin the throttle up a pretty nasty hill climb in 2wd, chain came off and I went ape sh@#$!! Bout rolled it down the hill... hoping the chain just came off but the small sprocket on the shaft coming out of the trans was gone, as well as the shaft it attaches to. Sheared the shaft off flush with the case..pretty wild break if u ask me! Does anyone have any idea how this could have happened and maby where to get transmission parts or have any advise on diving into this case. I'm a virgin don't wanna mess nuthin up any worse than it is maby I outta buy a new/ used one idk. Any feedback greatly appreciated

My daughters 2006 sportsman 700 efi only has 800 km on it and is like new but when the engine gets warm it will run only on 1 cyl but once it cools off it runs fine again, your help would be appreciated very much

So my last ride I had the throttle stick wide open! I used the kill switch to shut dwn the machine to a rolling stop. The throttle still stuck attempted to restart the machine with zero luck! The machine was towed back in “N”

The stuck throttle cable is resolved but the machine still won’t start......here is what I know so far!
Has spark
Getting fuel
Timing is correct
Fuse are good
Throttle body appears fully closed (some say it should be fully closed other say it shouldn’t be fully closed?!?!)
TPS - was reset in BUDS
In BUDS - no error codes listed
Crank sensor is ohm out at .925 Manuel states 700-900 (possibly bad?!?) however it doesn’t throw a error code in BUDS when unplugged?!?!

ANY THOUGHTS or SUGGESTIONS !?!?!

burns oil is this a crank case breather problem or do i need to rebuild the top end

Hey Yall just joined up here as i decided to join the can-am family.

I picked up a 2015 outlander 500 max xt dsp with 1000 1000 miles. Looks great couple little dings but nothing too crazy.
Now let some easy mods begin.
Im in manitoba hopefully some of yall are to.

Ill get some pictures up here in a few days

Looking for ideas or examples on where to mount a led light bar on my base 570. I don't have a push bumper and wasn't really planning on getting one unless I liked something I see. Also don't really want to mount it up on the front storage lid like I've seen some do, any input would be helpful thanks!

Any suggestions for best gun scabbard for a 17 Sportsman 570 with metal rack on the rear? All I'm seeing are ones that mount to the holes in the plastic rear rack that I no longer have. Thanx!

I left the gas cap off and rain got in , trying to figure out if there’s a spot I can drain the gas out of the tank/ lines as I imagine the water would settle at the bottom and get pumped first .

So I just put 26” tires and new wheels on my 2014 sportsman 400 and now it’s really sluggish. What can I do to regain some of the lost power? I know a clutch kit is a must if I can find one, but what else?

:cryingOK... my machine just started sputtering and smoking... the air filter was saturated with oil and airbox had a LOT of oil in it. Removal of filter cured sputter. When I remove the filter and top the oil up in the resevoir, it pumps a lot of oil through the left vent hose into the airbox, the level of oil in resevoir drops quickly and doesn't seem to return. Help! Really weird. Anyoine have this happen before? I get 110lbs of compression doing a compression test.