News

Hey guys,

So I have two 2004 trailblazer 250's that are in need of new plastics. One was beat the S:)& and the other I threw away before realizing how valauable they are.

Do any of you have suggestions on where to get used or new plastics from? I have been checking craigslist and the Facebook marketplace but no luck so far. Also eBay usually only has models from the 90's.

I appreciate any feedback you can provide!

New to the Can-Am game, Picked up a 2013 1000 XMR with 80 miles on it, the dude used it plow his driveway, to do this he added a Two Brothers exhaust & passenger seat. I live in Montana and it will be trail riding not mud. Will probably trade out tires for better trail/rock/snow tires. Not my first choice but he sold it cheap or should I say his wife sold it cheap!
My concerns after reading some posts is the exhaust temps with after market exhaust. Is there a need to add a fuel programmer to lower the temps or do the fuel programmers really work that well ? I live at 5300 ft so riding will be at that elevation or higher.

Hello all I am new to this forum and new owner of can am outlander max xtp 1000 2017 year.


So I bought this wiring harness for my led bar light.

https://www.ebay.com/itm/12V-40A-LED...72.m2749.l2649



And I did it like on this picture but now you can turn it on all the time even without key. My question is

1. How to wire it so you can only turn it on when the key is in the ignition and you have contact on?

Thanks for your help

Attached Images

File Type: jpg

s-l1600.jpg (75.0 KB)

I just bought my sportsman 500 runs awesome but when it gets wet it won't start I ohm every thing it's all at specs if set under cover 3 days it will start any body have any ideas

im looking at a set of used tires, and i was curious if i could get away with putting 12" wide tire on a 7" wide rim? i have no clue how wide is too wide thank you for the help

Had one of the electric fans go out on my 850. Pulled it apart to see one of the magnets broke and it burned up the brushes. Is there an aftermarket fan or can I buy just the motor instead of paying the $178 for a new one?

Been trying to find any and all information on why it overheats. There seems to be a lot of different theories from just reading online.

A few weeks ago I got on my parents Commander and I'm almost positive they overheated it multiple times but I could be wrong. So, I changed the thermostat and then the radiator cause it was pretty rough.
Added coolant, let it get warm and bled the heads. Coolant came out of both so I assumed it was fine.

Took it for a spin (Outside temp was around 24 degrees F) and within 200 yards it was overheating again.

Fan kicks on as well. Any ideas where to check next?