News

Hello, I am new so thank you for your patience. I have a 2016 Sportsman 450 that won't crank. When I turn the key over nothing happens, no clicking, no cranking, no nothing. But with the key in the run position or on position, when I jump the starter solenoid it starts fine and runs perfectly. Here is what I've done
Verified brake is on and the run/stops which is in the run position
Verified good battery connected correctly and bought a new battery just to verify.
Changed out starter solenoid
Changed out ignition switch
Checked all fuses and relays (in the fuse box), they are good
Circuit breaker has continuity, I removed it and jumped the two post with the wire still nothing.
The run/stop swhich appears to be working because it runs fine when I jump the starter solenoid.

I bought this bike 2 weeks ago not starting so I don't know the history, but it has 95 miles and 34 hours. I am out of ideas, if anyone has seen this before or knows what I'm missing I would love to hear about it.
Thanks in advance

Good morning guys. I have a 03 500 h.o. the issue is: new battery starts up fine. Lately When i run it, plowing, using the winch its good until the fan kicks on. Then it will bog down and sometimes shut off. Now, when i go to re-start, it has a hard time, like its starving for gas. I read on another site...similar issue the guy changed out the fuel pump. I ordered one and will be putting it on today. Im the original owner. Its never been changed so i figured id do it..but i have my doubts. Any ideas

Just bought a 17 Outlander 650 DPS starting the customizing.

Anyone know what all the 625w magneto and stock battery setup will push. I'd like to run hand warmers, 4-55w HID's, 2x240w light bars, while charging a cellphone and moving across the ice this hardwater season.

Figure you guys may have all the answers before I go break it myself.

Just bought a 17 Outlander 650 DPS starting the customizing.

Anyone know what all the 625w magneto and stock battery setup will push. I'd like to run hand warmers, 4-55w HID's, 2x240w light bars, while charging a cellphone and moving across the ice this hardwater season.

Figure you guys may have all the answers before I go break it myself.

For sale is my Polaris Glacier Pro Plow & Pro Frame mount with the ability to swivel the plow left or right with any easy lift of a lever.

I had it on a 2010 Sportsman XP 550.

All you need to do is purchase one of these 2 frame mounts (listed below) and you should be good to go. The frame mount attaches under the ATV and connects the plow system with a simple pull of a lever. Very easy to take off and on.


2879632 - SPORTSMAN XP 550/850 09-14, SPORTSMAN TOUR 09-14, SPORTSMAN X2 550/850 10-14, SCRAMBLER 13-14

2879633 - SPORTSMAN 570 2014, SPORTSMAN TOUR 570 2014, SPORTSMAN 400/500/800 11-14, SPORTSMAN TOUR 500/800 08-13, BIG BOSS 11-13

This setup is about 2 years old with extremely limited use. It's in very good condition.

Text Pete at 763-227-8611
$350 - located in MN

Attached Thumbnails

       

The atv won't start with pull cord. It doesn't want to start even with starter fluid. Engine did back fire finally after lots of pulls. any ideas?

I’ve been traveling for work the last four months and my 2014 Maverick has been sitting in my garage. I just replaced the battery and took it around the block for a spin, didn’t hammer down or anything crazy. I came to a stop sign and when i went to hit the gas, my bike didn’t move. Got out and checked under and found my drive shaft disconnected. I attached a picture of what i saw. Can anyone tell me what the problem is?

Attached Images

File Type: jpeg

36810490-3F05-4819-918E-983B4B9827A5_1513739648634.jpeg (973.4 KB)

Has anyone else installed the ultimate series rear bumper? I got an early Xmas present and I installed it today. What a PITA! The lower part of the bumper where you have to put the 2 bolts thru was my problem. I ended up taking the tires off to get a better angle. I was wondering if anyone else had an issue with that as well?

I also installed my hand and thumb warmers. That was fairly easy and now my hands will be toasty warm this winter. Next I will be installing my 3500# winch. Me and the wife are terrible with presents as we can never wait until Xmas to give each other our presents!. Attachment 96218Attachment 96226Attachment 96234Attachment 96242Attachment 96250

Attached Thumbnails