News

I am looking for some suggestions,i go to maine every year bear hunting but never get to just ride.i am taking the family to maine to see where I have been hunting for the last 16 years and we are bring atvs with us.anybody suggest a good place to ride that is family friendly.thanks for any info

Where to start I have changed all oils ????

Hello everyone!

First time on the Polaris atv forum. I wanted to inquire from fellow owners on a solution to a ongoing problem I'm having with my 2007 Polaris Sportsman 500 HO that has stumped me.

A few weeks ago out of nowhere my atv started idling funny. So I checked the tachometer and it showed it fluctuating from 1290 RPMs down to 900 and back. If I pressed the throttle however it had zero issues and ran perfect at full power. However as soon as I let off the throttle and go back to idle it begins running rough and even occasionally stalling.

Now I've done a fair amount of research on the issue, so I did the logical thing and started troubleshooting possible problems. Here's a list of what I've ruled out so far:

- Replaced IAC harness with new ModQuad harness (old harness and wires were chewed up)

-Raplaced IAC sensor with new one

- Replaced Fuel filter

- New UNI air filter

-Cleaned T-MAP sensor

-Checked fuel pump (working)

- Checked spacing on throttle (in spec)

-New Iridium plug

As of now I've replaced everything I could think of that might be the culprit and yet I'm still having idling issues. I noticed that when it starts up the first few minutes it runs perfect no idling issues whatsoever. However after the bikes fully warmed up and running for awhile it starts stuttering and the idle goes back to being erratic. What else could be contributing to this issue? I'm out of ideas unless the t-map sensor is bad? I open to any suggestions!


Thanks!





Sent from my iPhone using Tapatalk

I have a 2017 Outlander 1000xtp. I am having an issue where I have to rock the machine back and forth to get it into park. This is a pain when in the back of pickup. If the atv is running and you go from park to reverse the machine jerks/moves slightly. The same thing happens when you go from Neutral to drive.Machine has around 300 miles maybe less.

My prior machine was a 2016 renegade 1000r and it never had this issue.

The machine is currently getting its first service done and they said that they did not notice an issue. How can the machine jerking when you put it into gear not be an issue. This happens at any engine temp when at idle. Not sure if the service fixed it since I will not be picking it up until Saturday.

Is there something I should have them check?? I know its not normal because my renegade didn't do it and it was the same motor and trans.

Any help would be greatly appreciated.
Thanks,
Luis

hey guys, I have been looking for a decent pair of chest waders for awhile now and looked on Canadian tire, Cabelas and a few other places and I came across a brand online called Gator Waders. they look decent, and wondering if anyone has tried them out or any brands of waders they live by.

Thanks

Love riding this time of year!
https://youtu.be/Xi3KehU0rmQ

Hello
I'm new to the forum. I found this site searching form my problem. Looks like a awesome site.

Anyway I am rebuilding my carb on a 03 sportsman 500 ho. After days of soaking and heating I finally got my mixture screw out. I need a replacement screw. Does anyone know where I can get one? I searched all over the web. I don't think any of the diagrams even show it. The only place I havent made it to yet is a dealer.

Any help is greatly appreciated
Thanks in advance

My sportsman 500 needle and seat went bad filled the motor with gas I changed the oil put a new needle and seat in now it's seems to be running a little rich the plug gets black sute on it. It also idles up and down after running for awhile and will some times quit. Any ideas what I should check ?