Posted on

Front rack /rifle mounts?

Looking for a way to attract a rifle/bow mount to the front box without drilling the box.

Any front racks that will allow me to clamp on a rifle/bow mount?
If so please provide a link.

Thanks
Dave
Posted on

Noisy starter drive

Hi everyone I've got a 2013 400xt, 700 kms...My problem STILL,after hours of work is that my starter makes light noise on engagement and then holds on for a good second or 2 befor letting go...I removed the drive ( not fun) took it apart,looks clean and smooth,cleaned it anyway, splines, weights, shaft...still noisy..would put new one in but they now want $560:00 at my dealer...sure would like to here if anyone else has had to eat this...P/S..BAT 14.2...approach angle looks good,plastic retainer not broken...Any help would be appreciated...thanks
Posted on

Dies when riding

Don't hang me,I looked and can't seem to find what I'm looking for.i have a 2014 570.the battery was dead from sitting for a little bit so I put the jump pack on it to get it going quick.problem I'm having is that it will start right up and run ,but once I start to it will die on me.used jump pack again and had same results. No lights were running nor was the winch being used. Could it just be a bad battery or something else?
Posted on

Ranger 500 belt slipping

I am working on a Ranger 500 EFI that is slipping the belt. Put a new OEM belt on it with the same results. The primary clutch seems to be working fine, I did pull it apart and clean it out. My question is how do I determine if the secondary clutch is working properly?

I have a clutch press coming, but I tried my tire bead breaker (very lightly) to see if I could compress it enough to get the c-clip out and it didn't seem to want to move.......
Posted on

Sportsman 450/570 Right side excessive heat ASA-17-01

I just received a service bulletin for a RH side panel close-off kit. Enough complaints were submitted (including my own) for Polaris to correct this excessive heat issue. Here's the rub...my dealer told me that unless you receive a notice from Polaris....dealers probably won't contact the registered owner. If you have this bike and don't like the heat...contact your dealer......just a heads up.....

Sent from my SM-T700 using Tapatalk
Posted on

2013 Renegade 800r Rad Fan

Alright, long story short. This is my first Can Am. I've had the bike out for one run so far, which consisted of a lot of mud. Before taking the bike out, I noticed the rad fan was not in the best operating condition. At the end of the run, right when I was loading it into the trailer, it seized up. I have one on order, should be here within the next two days.

Does anyone have a DIY on how to remove the fan without removing the plastics, or rad? With just a quick glance, I can see the obvious four bolts ( one on each corner ) I pulled those out, but it is still in there solid. I didn't have much time to look at it before leaving for work. If anyone could give me any tips, it would be greatly appreciated.

Thanks guys!