News

Hi all from S.E. Mi.

I'm wondering if anyone has any ideas on this:

I'm getting back into quad riding and have a new 1000XP Touring and I find if I ride for more than a half hour or so, the pad of my right thumb gets sore. I tend to place it on the edge of the throttle level, which obviously isnt the best place but any lower down (on the flat side), seems a bit of a stretch.

Does anyone know of an accessory or adjustment to help with this?

Thanks,
Scott

I have adjusted the rear preload up one notch from lowest setting as I carry a passenger on the back. I am wondering if I need to adjust the front to match or how it will effect ride to only adjust the rear? What do you guys normally do for a passenger? Both riders are around 120lbs. Not a touring model.

Just sealed up the entire belt box in a sportsman 1000 highlfiter 2017. Found this in the skid plate. I know for sure I didn't take any allen bolts out except the drain and fill plugs on the diffs. So my question is any ideas where this came from? Thanks for any suggestions.

Sent from my SAMSUNG-SGH-I537 using Tapatalk

Used 07-08 Outlaw 450/525 lone star a-arms. +1 width +1 length . repainted and new ball joints. Included are the tie rods and kashima fox floats RC2 w/ 1 off carbon fiber guards. Shocks are 19 3/4" length.12 hours on complete rebuilt. Asking $1300 awesome set up!

Attached Thumbnails

         

2012 polaris sportsman 800 Efi.
Got the bike out to do some running around. It's probably been sitting in the shop a month or so. I noticed it was idling rough and when I gave it throttle it kinda cut out. After a second it cleared up. Then at idle it would die every now and then.

Decided it needed fresh gas. Filled it up and ride about 30 minutes and it's still doing it intermittently.

Any ideas would be greatly appreciated.

Sent from my SM-G955U using Tapatalk

I have a 2010 sportsman 550, and I can get a set of wheels that came off a RZR I need to know if they will fit my sportsman, without spacers? Thanks

Like the title says my 2006 sportsman 500 ho won't start unless I put my hand over the air intake tube. Once it's started it runs great like normal. I recently replaced the fuel pump and it seems like the new pump is fine. But, is there something I missed that may be causing this problem?

After years of rock solid reliability from a 2004.5 500HO (bought new) and a good 09 300 my friend decided he'd buy a 2016 570 EPS last fall.

This has been a headache for him...


'The plastic not fitting, Polaris telling me to drill holes in it and
use push-pins or screws to hold it together.
The rotting exhaust after one ride.
The heat.
The having to pay a $56 deductible to use the warranty at 20 hours
because the water pump housing was bad, and the clutches were not
aligned.
The cracking Lock and Ride windshield.
Headlight bulbs burning out at 20 hours.

And you can say I called Polaris after my dealer could care less and
Polaris had nothing to say and were not concerned at all. And offered
to do nothing.

And in the case Polaris may look at these forums you can say I have
three Polaris's for sale and am changing brands.'

My reason for not buying another, my 400HO will be my last.