News

I just restored an older Trail Boss 250 this is my seven digit vin 1462699 any help with this

Can anyone give me a link to where all of the large black ground wires go on this thing? Also any link to a wiring diagram other then the one in the manual? Thx

Recently purchased 2013 Sportmens. This is only my 2nd ATV and i'm not overly mechanical, but it's little hard to shift compared to Suzuki Eiger I had previously. I was going to adjust the idle screw as ATV idles at about 1450, but it's about the same to shift when running or not running. However, cannot easily locate the idle screw. Not really hard to shift, but harder than I expected. I've changed the motor oil and trans fluid about a week ago when I got the ATV. ATV has 31 hours and 750 miles if that helps. Maybe this is just the way this Polaris shifts. Thanks for any input.

my stock springs are weak on my 01 sport mans 500 HO RSE. does any one know if the front springs from a 2015 sportsman 570 will fit?

I still have a lot of pieces. engine is no good. rod broke and put a hole in the block. let me know what you need. txt 808-256-5051

I smoked my drive clutch on my Sportsman 500 with EBS and I'm considering replacing with a non-EBS drive clutch.
The EBS for me is really unimportant as a feature. My property is flat and level so I'm not concerned about losing this feature.
Is this as simple as just buying a Non-EBS clutch and swapping it out? or are there any other considerations. I guess I'm unsure if all of the EBS functionality is contained in the drive clutch itself?
Your technical help is appreciated!
Thanks, Dave

Who is running light bars on their outlanders?

Where/how did you mount them?

thanks.

This thing is a beast!!

Attached Thumbnails

       

I need to replace my ecm from My 09 Outlander. I have found a used one from a 2010. They look to be the same. Numbers vary by the last single digit. And the 2010 has ignition switch mounted on side of it. Anyone out their have any advice for me as to if this one will fit and work?

I need to replace my ecm from My 09 Outlander. I have found a used one from a 2010. They look to be the same. Numbers vary by the last single digit. And the 2010 has ignition switch mounted on side of it. Anyone out their have any advice for me as to if this one will fit and work?