Author: Forum News

Are you guys getting aftermarket primary and secondary or just modding the primarys?
Modding them with a spring kit and locking them out.



Sent from my SM-N950U using Tapatalk

So born and raised in Miami , i am working on moving to GA. " I belong in the woods ". At the moment i am looking to relocate to the Canton area. I was wondering if theres some good riding locations up there ? Or anywhere in northern GA ?
Thanks Everyone..

What are the disadvantages of a larger engine in a ATV .This is not a troll I just want to have a conversation . I love power and have two 1000s ATVs and ride about 5,000miles a year :devil

Was looking to replace my son's 09 Yamaha Grizzly 450, and found a good deal on a 2017 Sportsman 450 HO in sage green, 111 miles, 9.3 hours on craigslist for $3700. Looking forward to getting him out on it!

I am replacing my frail on my sportsman 570, the used frame I got has some surface rust. I was thinking of repainting the frame. What paint would people recomend? I was trying to protect the frame from further rusting. One friend was suggesting a spray on bed liner.

Hi guys

I've got the alpine plow for my outlander and my pins are bent all to hell, so I'm trying to find a replacement part or if anyone has suggestions. I called my local can am dealer and they said they were not able to order them separately and i'd need to buy the entire hardware kit. Sorry if this post is in the wrong section.

After seeing numerous situations where the machine gets hung up on the floorboards I'd like to prevent that. It's difficult to tell from looking online if there are any skid plates that extend to the outer edge of the floorboards. If there are, which ones? If not, does anyone have any pictures of custom made rock sliders?

2004 sportsman 500
does this look like a aftermarket axle, ??
i've seen vids where guys pull hard a couple times on the axle and it comes right out at tranny.
I was changing the outer cv boot and knocking on appropriate spot and it was not working so i said ill see if i can take whole axle out and it will be easier take outer joint apart and to regrease both boots and reclamp.
Can i just reinstall ballbearings in cage and it will fit back in axle housing ?
I dont want to pry between tranny and axle end.

Attached Thumbnails

 

Hey so I found a guy selling the display unit off of a brp sled and wondered if it would work on a gen 2 outlander. Any ideas? Pics show the serial number

Attached Images

File Type: jpg	20171109_123557_1510253811022.jpg (2.30 MB)
File Type: jpg	20171109_123540_1510253848200.jpg (2.81 MB)

Due to old age and arthritis I find it hard to get down and connect a battery charger to my 2015 Sportsman ETX EFI. When I take the seat off there is a red boot that looks like a sparkplug boot just under the seat at the left front. I thought perhaps it was a connection I could connect my charger to that would ease charging the thing. When I pulled the cap off it slid off leaving a grey L-shaped connector and the wire stayed in the boot. What does this go to? I have pressed the boot back on but can't seem to get it seated all the way. The engine starts and runs fine but I need to know what this is and did I damage anything?
I dropped a picture below.
Thanks for any info!

Attached Thumbnails