Author: Forum News

Hey all,
We purchased this about 1 month ago and we have 420 miles on it. Yesterday we went on a 26 mile trip and while accelerating the drive belt exploded. Of course I didn?t have a spare. My buddy was at camp and went to a store and bout me two so I now have a spare.

Anyway, I was crusing along after the belt change to break in the new belt not going over 40. All of a sudden I looked down and the engine light is on and it is in limp mode. I stopped check oil, air filter, wiring etc. and everything seems fine. I started it and we were on our way. The engine light cleared and then came on a few minutes later and we were back in limp mode.

I checked the engine codes and it says there are none stored. I am taking it to dealer on Thursday i hope they can fix it. I will keep you updated. Rant over

Hey fellas,

I'm puzzled with this one, I have a 2008 Outlander 650 at. Bike worked great till the other day when I went out for a ride. Basically anything over half throttle and 42mph or so it misses and almost dies at times. Here's what I did so far, changed plugs, new coil, new fuel pump and filter and still nothing so I checked the timing cause there known to jump from time to time but all is good! So my question is does anyone have any more idea on what it could be? Also there is no p codes showing.

2008 CanAm Outlander 650XT
HMF slip on pipe
Clutched on 30" Silverbacks
Snorkeled and rad relocate

I have a 2015 maverick xxc with about 900 miles on it When I checked the oil the last time it was low so I added some and I checked it about 2 weeks later it was low again can someone help

Wondering if anyone has any input on the hmf or big gun exhausts for the 570. If like a deeper tone then the factory I know it's not going to be a performan gain just want it to sound meaner. I'm not a fan of the exhaust mod because from what I can tell it only hinders your performance once it's under water and I don't want that. I'm also curious as to how they run without a tune the only person I see tuning them is rvs and I can't get a reply in here from ryan.

I've went from rebuilt carb, new plug, pull carb on and off to clean several times. I have been able to get it running but eventually problems arise hard to start, bad idle, flooding etc.... here is where I am now.

I can start it but immediately it starts to wanna flood out. If I hit throttle it just bogs it down. Any ideas?

I have been reading up on clutch kits and complete clutch units.
I have done clutching on snowmobiles and had big improvements.
I have a 2017 650XT. I am not going mudding or racing. I'm riding trails with hills and and puddles.
I've been looking at the EPI and Dalton kits.
I'm also going to plug in a Dobeck EJK as soon as my warranty is up.
Any advice on your experience will be appreciated.

Sent from my XT1080 using Tapatalk

I just purchased my first ATV.
A 2017 650XT.
We move to the north woods of Minnesota and our new property is in the middle of the trail system.
I'm a service technician at a domestic car dealership.
I'm here to learn and share with everyone.



Sent from my XT1080 using Tapatalk

Good morning all, need some help from the community.

Did full service on the bike all fluids etc.

I’ve got a drip out the front diff drain plug now. Pulled the plug and looks like the first three threads in the diff have stripped out. Drain plug won’t seal right now. Anyone know of a thread repair kit that’s an easy install? I’ve got a helicoil repair kit but way too big not too psyched on drilling a half inch hole in the bottom of my diff.

Thanks for any help provided
Dan

New Member Hello , from PA.

I'm new here so please bear with me. just bought a 2017 Commander XT 800. Third time out and the thing started bucking on me when i tried going up hill. Then it started smoking. Any ideas?