News

I should be taking delivery of my xmr in about a week, does anyone know where i can buy A-arm protection?

Can-Am does Not have these available yet and the ones from the 2019 xrc do not fit for some reason.

Also does the xmr and the arc have the same underbelly protection?

So after an accident some years ago, I finally got around to rebuilding my scrambler.

I'm trying to get it to fire and run. It will run on starting fluid but not on fuel. I pulled the carb and cleaned it throughout. It looked great. I believe I rebuilt it before the accident. I reset the float levels and confirmed I have fuel in the bowl.

If I cover the carb inlet with my hand and allow just some air through my fingers, it will fire.

What an I missing here? Shouldn't it for and run with an open carb intake?




Sent from my iPhone using Tapatalk

I've been working on my '04 Sportsman 400. It doesn't want to idle without the choke on, at least partially. It starts right away, but as the choke automatically goes in it starts to idle roughly and then sputters out. I bought this a few weeks ago and so far have replaced: air filter, fuel filter, gas in the tank, spark plug, oil change.
After its been driven around a bit it seems to idle better - but initially I can't get it to idle at a low enough RPM to put it in to gear. I have to push the choke in, wait for the RPMs to come down, throw it in gear and push the throttle quickly before the engine dies.
Looking for some direction as to what to explore/change. Thanks!

I've been working on my '04 Sportsman 400. It doesn't want to idle without the choke on, at least partially. It starts right away, but as the choke automatically goes in it starts to idle roughly and then sputters out. I bought this a few weeks ago and so far have replaced: air filter, fuel filter, gas in the tank, spark plug, oil change.
After its been driven around a bit it seems to idle better - but initially I can't get it to idle at a low enough RPM to put it in to gear. I have to push the choke in, wait for the RPMs to come down, throw it in gear and push the throttle quickly before the engine dies.
Looking for some direction as to what to explore/change. Thanks!

Hi team is there a match for polaris sportsman 400 wheel bearings other than ome?

I heard that you can adjust the secondary spring or something and get some performance back after bigger tires without doing a complete clutch kit.
Any ideas on this?

I am in need of a high beam bulb for my 2008 Sportsman Touring 500. I know it is a 886. But are there different 886 bulbs? I saw some listed as fog light bulbs and others did not. Is there a difference or are all the 886 the same?

I want to make sure I order the correct one.

Thanks

ok i have a 1996 trailblazer and had to get a new carb for it the person i bought it off of put a honda carb on it so i bought a new carb and the carb does not have an oil line hook up like my 2002 blazer does so i was wondering dose the oil go straight to the engine right from the oil tank?

Here is my 2019 can am outlander XT 650 camo

Attached Images

File Type: jpg	IMG_20181214_164739_1544827142465.jpg (4.00 MB)
File Type: jpg	IMG_20181214_162007_1544827159585.jpg (3.63 MB)

Does anyone know if the vehicle width is different with tracks versus the 62 inches when measured with tires? Need to determine the width with tracks to determine if my trailer is wide enough to transport. Thanks in advance.