News

Hello all,
new to the forum. I ride a 2017 Outlander 1000r xtp triple black. 8 hours so far.

last ride water out 400 and 800max xr belt was gone getting new coves with drain and going to reseal-and add cvt teck clutch andevo pipe- hope this helps as far as 400 just going to re seal its old but runs good air box is low-water and belt don't mix :grin:grin:th_smiliewavey: lots of watering florida

Looks like I will be picking up a 2003 Polaris Sportsmen 500 HO today, I want to start thinking about adding a winch up front. Can anyone give me advice on what set up will fit this atv? Pictures would be great if you have a few

ThanksAttachment 112397

Attached Thumbnails

 

Finally decided to sell the 16’ XMR 570 & got a new 2018 XMR1000R.
Was wanting your guys input on the best mods for these machines, any advice is appreciated!



Sent from my iPhone using Tapatalk

Hello everyone, can someone recommend some fuel filters that I could use instead of the dealer filters?

Thanks

So I purchased a new 650XT last month for my wife to ride. The first day I was riding around the yard and experienced this grinding noise coming from what I suspect to be the clutch/belt or CVT. It happen when the machine had about 1 mile on it and I couldn't reproduce it again until this past weekend and now it has 150 miles on it..

Conditions for the video - I was in LOW, going down a hill (on my driveway) and you'll hear the sound in the video.

I've owned a ton of toys, never had anything make a noise like this thing.. Before I hit up the dealer I wanted to see if anyone else is experiencing something like this..


https://youtu.be/gJAXr15p_5c


I'm fixing the sidways video right now..

I’ve gotten much useful and needed info from this site. I appreciate it.

When setting out the trash from my shop the other day, I got to thinking about all the useless throw-away junk in it – how it would tell a little bit of a story about me.

What YOU throw out each week could almost be a short-term diary of YOUR life.

Just for the heck of it, here is a (very abbreviated) list of some of the stuff in this week’s trash at my place

What’s in YOUR trash?

Empty water bottles and caps
Empty beer bottles and caps
Dull needles (from working calves)
Dirty bore patches
Broken drill bit
Shell casings
Empty medicine bottles (calves)
Shot-up targets
Shop towels (too greasy to put in wash)
Partly-used tube of super glue (from closing cut in hand)
Sawdust, dirt, metal shavings, etc. from shop floor
TSTS pieces of baling wire (too short to save)
Bloody duct tape (ran out of Band-Aids)
TSTS baling twine
Used gasket
Used oil filter(s)
Small pieces of survey tape (long story)
Empty grease tubes
Bad temp gauge off of smoker
Welding rod butts
Empty snuff cans
Burned out bulb
Used nitrite gloves
Dull hacksaw blade

That’s only scratching the surface. Pitch in if you feel like it. Just for grins.

Hey all, can someone tell me whats the correct or the BEST spark plug and proper plug gap for my 2015 outlander 800xmr. Im leaving thursday night to go riding for the weekend