News

I Snapped the rear driver side inner CV joint - I have the unit disassembled but without the outer part of the axle to yank on I am having trouble getting the inner joint out of the rear diff - anyone have any great ideas ?? Any help would be greatly appreciated - So far I have tried a long pry bar from behind the rear bumper on the lip where the boot clamps and hitting it but no luck

The plastic that is around the speedo and headlight broke. Anyone have one , preferably in red?

Finishing up a ride when I hit a blacktop stretch ....I went wide open throttle and tell the rev limiter hit. At that point the throttle was stuck wide-open banging the rev limiter, I hit the kill switch and came to a coasting stop. Play with the throttle didn’t seem to make any difference on being stuck open tried starting the bike all it would do is crank.

Took the throttlebody off and cleaned it out, now the throttle functions properly “ can’t replicate it to get stuck again” however it still won’t start!

Hooked up BUDS and seen the TPS was at 1.5 reset the TPS to 0.0 bike still won’t start.

Thoughts.......

Before I buy, I would like to get an idea of how many people on this forum are using this head, how much use have you put on them and if you have had any issues.

Thanks!

Sent from my SM-N950W using Tapatalk

Hey guys, looking for a fuel pump hanger from a 2004-2007 Sportsman. Let me know if you have one available. Would love to find one with the gasket, the pump does not need to work, I just need the hanger.

I picked up my first ATV today. A used 2012 MAX XT 650 with 2,000 miles on it. It seems to have been rode very easy and looks to be in great shape. Looking forward to learning from you all on here about tips and tricks to maintaining a good machine.

Attached Images

File Type: jpg	Home3_5.31.18.jpg (3.09 MB)
File Type: jpg	Home2_5.31.18.jpg (2.29 MB)
File Type: jpg	Home1_5.31.18.jpg (3.50 MB)

Can anyone out there provide me the measurement between the two mounting points on the plow frame where it mounts to tube on ATV?

I have a 2017 Sportsman 850 that has factory tubes on front of machine. I have an opportunity to buy a Glacier II for a good price. I realize it is made for older models but It looks like it may actually fit. The guy is not getting back to me with the measurement. If it is anywhere close to 12 1/2 " between the mounts, It should work.

Anyone with this model, could you please measure and send me a pic or the measurement?

Thanks in advance.

I have a 1995 trailboss 250 and my chain is loose. How do I tighten it

Proszę o pomoc w odpowietrzeniu polarisa jak to zrobić

Wysłane z mojego F3211 przy użyciu Tapatalka